User manual MGA ENTERTAINMENT BRATZ FOREVER DIAMONDZ FASHION SHOW ON THE GO 3 4

[. . . ] As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not expose batteries or apparatus with battery-installed to excessive heat such as sunshine, fire or the like. [. . . ] Press DISPLAY when playback is stopped. The Control Menu appears on the TV screen. Press or repeatedly to select "PROGRESSIVE (COMPONENT OUT), " then press ENTER. The options for "PROGRESSIVE (COMPONENT OUT)" appear. Press or repeatedly to select (SETUP), then press ENTER. The options for "SETUP" appear. Continued GB 7 Press or repeatedly to select the desired setting, then press ENTER. The default setting is underlined. Select this setting when: your TV does not accept progressive signals. your TV is connected to jacks other than the COMPONENT VIDEO OUT jacks. Select this setting when: your TV accepts progressive signals. your TV is connected to the COMPONENT VIDEO OUT jacks. When you select "ON, " the confirmation display appears. Follow the steps below. 8 Press or repeatedly to select "START, " then press ENTER. The system outputs the progressive signal for 5 seconds. Check that the screen is displayed correctly. 9 Press or repeatedly to select "YES. " The system outputs the progressive signal. When you select "NO, " the system does not output the progressive signal. There would be no image on your TV or the image is not clear if your setting does not match your TV or connection. Note 0GB When using a TV Turn on the TV and select the video input so that you can view the pictures from this system. Setting the LCD You can make adjustments to pictures displayed in the LCD. Use buttons on the unit and confirm operations in the LCD, for the following settings. Note Playback settings stored in the disc take priority over the LCD settings. Make sure that the headphones or microphones are not connected. Otherwise, you cannot perform "SPEAKER SETUP. " 3 Press FUNCTION +/ repeatedly to select "DVD" (or press DVD on the unit). The guide message appears at the bottom of the TV screen. Continued GB 6 Press or repeatedly to select the setting that matches your TV type. If you have a : standard TV: Select "4:3 LETTER BOX" or "4:3 PAN SCAN" (page 60) If you have a wide-screen TV or a : standard TV with wide-screen mode: Select "16:9" (page 60) To recall "QUICK" setup settings 1 Press DISPLAY when playback is stopped. The Control Menu appears on the TV screen. (SETUP), then press ENTER. 2 Press or repeatedly to select 3 Press or repeatedly to select "QUICK, " then press ENTER. Note 7 Press ENTER. The setting is selected and "QUICK SETUP is complete. " appears on the TV screen. If you want to change each setting individually, see "Using the Setup Menu" (page 58). The guide message appears at the bottom of the TV screen when you turn on the system for the first time or after performing "RESET" (page 120). If you make a mistake To quit "QUICK" setup Press DISPLAY. Press , then select the item again. GB Using the "THEATRE SYNC" function THEATRE SYNC allows you to turn on your Sony TV and this system, changes the system's function to "DVD" and then switches the TV's input source you have set with just one button. Operating the "THEATRE SYNC" function Keep the remote pointed in the direction of the TV until the TV is turned on and the input source is changed correctly, then press THEATRE SYNC. If this function does not work, change the transmission time. The transmission time varies depending on the TV. Getting Started Preparing to use the "THEATRE SYNC" function Register the TV's input source connected to this system. To change the transmission time Press 1 2 3 4 5 6 7 8 Note Press the following buttons while holding down . Transmission time (seconds) 0. 5 (Default) 1 1. 5 2 2. 5 3 3. 5 4 To select the TV's input Press 0 1 to 8 9 CLEAR + Press the following buttons while holding down SLEEP. TV's input source No input source (Default) VIDEO 1 to VIDEO 8 COMPONENT 1 COMPONENT 2 COMPONENT 3 COMPONENT 4 This function is only for Sony TV series, however, some TV products may also not work. The selected TV's input source is memorized into the remote. GB Disc 3 Load a disc with the label side facing up on the disc tray. To load additional discs, press DISC SKIP/EX-CHANGE on the unit to rotate the disc tray. Playing a disc Depending on the DVD VIDEO or VIDEO CD, some operations may be different or restricted. Refer to the operating instructions supplied with the disc. DivX and MPEG4 video files can only be played back on MHC-GZR33Di. [. . . ] CHAPTER: repeats the current chapter. Continued 7GB When playing a VIDEO CD or AUDIO CD: OFF: does not play back repeatedly. ONE DISC: repeats all the tracks on the current disc. When playing a DATA CD or DATA DVD: OFF: does not play back repeatedly. ONE DISC: repeats all the folders on the current disc. [. . . ]