User manual MICROSOFT NOTEBOOK COOLING BASE PRODUCT GUIDE

[. . . ] 59 Microsoft Product Guide Read this guide for important safety and health information and the terms of the Limited Warranty that apply to the Microsoft® device that you have purchased. Read this guide and keep all printed guides for future reference. Com/hardware or refer to the Microsoft Help and Support section for contact information. This document includes important information about many Microsoft products. [. . . ] — Do not allow minors to use a pointer unsupervised. A reflected beam can act like a direct beam on the eye. — Do not disassemble the device. — Do not use the device outside of its specified operating temperature range +41ºF (+5ºC) to +95ºF (+35ºC). If the device is exposed to an environment outside of its prescribed operation, turn off the device and allow the temperature to stabilize within the specified operating range before using the device. Do Not Attempt Repairs Do not attempt to take apart, open, service, or modify the hardware device or power supply. Doing so could present the risk of electric shock or other hazard. Any evidence of any attempt to open and/or modify the device, including any peeling, puncturing, or removal of any of the labels, will void the Limited Warranty. Choking Hazard This device may contain small parts which may be a choking hazard to children under . Indb 5 6/3/08 1:50:23 PM Usage and Cleaning Use in accordance with these instructions: ● Do not use near any heat sources. Keeping Cables Out of the Way of People and Pets Arrange all cables and cords so that people and pets are not likely to trip over or accidentally pull on them as they move around or walk through the area. When the product is not in use, you may need to disconnect all cables and cords from the front and rear of the product to keep them out of the reach of children and pets. Do not allow children to play with cables and cords. Laser and LED Specifications Caution Use of controls or adjustments, or performance of procedures other than those specified herein may result in hazardous radiation exposure. Laser Devices This device complies with International Standard IEC60825-1:1993+A1+A2 (IEC 60825-1:2001-08) for a Class 1 and Class 2 laser product. This device also complies with 21 CFR 1040. Class 1 Laser Devices CLASS 1 Beam description: Collimated (parallel) beam of infrared light (invisible to LASER PRODUCT the user) IEC 6082-:200-08 Laser power output: < 76 microwatts (at 82 nanometers) to 8 microwatts (at 86 nanometers) Emitted laser wavelength: nominal: 80 nanometers, range: (82 – 86 nanometers) A Class  laser product is safe under reasonably foreseeable conditions of operation as described by IEC 6082- and 2 CFR 00. However, it is recommended that you not direct the laser beam (which is emitted from the bottom of the device) at anyone’s eyes. Class 2 Laser Devices Beam description: Collimated (parallel) beam of light Laser power output: <  milliwatt Emitted laser wavelength: 60 – 670 nanometers This optical device has no serviceable parts. The Class 2 laser beam is emitted from the front of the device. This product uses LEDs that are considered Class 1 (IEC60825-1:1993+A1+A2). However, it is recommended that you not direct the light (which is emitted from the bottom of the device) at anyone’s eyes. [. . . ] You need not register Your acquisition of the SOFTWARE and Hardware Device for the Limited Warranty to be effective. To the extent allowed by applicable law, the Limited Warranty is only made to You, the first licensed user of the SOFTWARE or purchaser of the Hardware Device, and there are no third party beneficiaries of the Limited Warranty. Except as required by law, this Limited Warranty is not intended for and does not apply to anyone else, including anyone to whom You make any transfer as authorized in the Agreement. Microsoft is the warrantor under this Limited Warranty. [. . . ]