User manual MICROTEK ARTIXSCAN 2020

[. . . ] Microtek ArtixScan 2020 User's Manual English Copyright 2000 by Microtek International, Inc. All rights reserved. Trademarks Microtek, ScanMaker, and ScanWizard Pro are trademarks of Microtek International, Inc. IBM PC is the trademark of International Business Machines Corporation. Windows and MS-DOS are trademarks of Microsoft Corporation. Other product or company names are trademarks or registered trademarks of their respective holders. Important Documents that you scan may be protected under copyright law. [. . . ] Install the AVA-2903E interface card (Refer to Step 1 on page 2) Note: Windows 98 should automatically detect your new hardware and install the proper drivers, upon restarting your computer. Check interface card status (Refer to Step 2 on page 2) Note: If a conflict exits, refer to "Troubleshooting for Windows 98" on this page. Install your software (Refer to Step 3 on page 3) 4. Reset the scanner's SCSI ID if necessary (Refer to Step 4 on page 5) 5. Connect the scanner (Refer to Step 5 on page 5) 6. Test your scanner (Refer to Step 7 on page 7) Troubleshooting for Windows 98 After installing the interface card in your computer and connecting the scanner, you may find yourself unable to use the scanner. This is usually due to any of the situations described below: Situation A Resolving situation B 1. Cl c Start, Settings, and select Control Panel. Double-click on the System icon in Control Panel and select Device Manager from the top. Double-click on "SCSI controllers" to display the dialog box below. Your interface card is not properly seated in the PCI card slot on your computer. Your interface card conflicts with another device. Windows 98 cannot recognize your interface card. If your interface card and scanner do not seem to be working properly. Situation B Situation C Situation D See details below for resolving the individual situations. Resolving situation A A yellow exclamation mark appears next to the message "Adaptec AIC7850 PCI SCSI Controller". Power down your computer, remove the AVA2903E interface card from your computer. Then reinstall it, make sure the card is seated all the way in and secured into the PCI card slot. The PCI card slot normally appears in white or ivory. 4. Click on the Adaptec AIC-7850 PCI SCSI Controller option, and then click Properties. 10 5. The dialog box gives you information about the 3 resources: Interrupt Request (IRQ), Memory Range, and Input/Output range. Any conflict in the 3 resources is detected and displayed in the "Conflicting device list". To resolve the conflict, uncheck "Use automatic settings", then click to modify the individual resource, one after another, until the message "No conflicts" appears in the Conflicting device list. For example, to resolve the Memory Range conflict, take these steps: a) At the Resource type, double-click on the Memory Range string, the Edit Memory Range dialog box is displayed. 7. When you get a "No conflicts" message is in the Conflicting device list, the Memory Range conflict is resolved. Take the similar procedures on the Interrupt Request (IRQ) and Input/ Output Range resources. [. . . ] The carriage must be locked to prevent the mechanism from moving during shipping and getting damaged in the process. In addition, you need to pack the scanner in the original box in which it came. No scanner will be accepted in a packaging other than the authorized Microtek packing box. If your box is lost, call Microtek Sales to purchase a new one. [. . . ]