User manual MICROTEK ARTIXSCAN DI 6240S

[. . . ] Start Here Unpack Contents Unpack your scanner package and check for major components. Scanner Hi-Speed USB cable Software CDs/DVDs Power cord Power adapter 2 Installing your Microtek ArtixScan DI 6260S/6250S/6240S & ArtixScan TS 630S 5 1 4 3 Install Software Important: You must install software before connecting your scanner. Always close any open programs, and turn off Anti-virus utilities before installing software. Place the Microtek Software CD/DVD into a drive, and follow the on-screen instructions to install the scanner driver and software. [. . . ] Click the Scan Setup button in the interface to activate the Scan Setup interface. In the Scan Setup interface, follow the steps below to specify your basic settings. A) Select ADF (Front Side), ADF (Back Side) or ADF (Duplex) in the Scan Source as your image input device. Select Auto Color Detection to scan the image in color or non-color based on the automatic judgement and detection of the system. €“ Select Complex to scan the image in color, grayscale or non-color based on the customization. C) Select a dimension in the Paper Size as your preview image size. D) Select a desired resolution in the Resolution for your image output resolution. Click the Preview button to perform a preliminary view of the entire image. When done, a preview image appears in the Preview window. Do not forget to put the document back on the document feed tray. Go to the “General” panel by clicking the General tab in the Settings window. Specify the settings for your requirements there. A) If necessary, specify the image settings for the front or back side of documents separately by using the Sides of Material control when Scan Source is set as “ADF (Duplex)”. C) If necessary, check “Double Feed”, then select a suitable paper thickness for the ultrasonic double-feed detection in the Paper Type options menu to prevent multiple pages from being fed together while papers are fed through the ADF. D) If necessary, check “Auto Document Rotation” to ensure the scanned images in a readable orientation. When it is checked, you can select the preferred language used as an identification in the options menu. E) If necessary, check “Remove Blank Page” and “Remove Punch Hole” to enhance the quality of the scanned images. If necessary, go to the “Image Process” panel by clicking the Image Process tab in the Settings window. Click the OK button to close the Scan Setup interface and return to the Main interface of ScanWizard DI. In the Main interface, click the File Format menu button to select a file format for the scanned images. In the Main interface, click the File Name menu button to specify a file naming method for the scanned images. In the Main interface, select and click the Normal Scan button to start scanning. [. . . ] Click the “Cancel” button and close the ScanWizard DI or ScanPotter Control Panel. Disconnect the Hi-Speed USB cable from the back of your computer, and refer to the installation instructions in this guide . When trying to scan, an error message appears on your screen that reads, “Can’t Find Scanners”. Make sure your scanner is connected to your computer and plugged into a power source (see Step 4). [. . . ]