User manual MICROTEK GNC M 527C 0304

[. . . ] Connect the equipment into an outlet different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit. The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. i Radio Frequency Interference Statement Warning: This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures. [. . . ] "Hot Keys" for Quick Adjustment of Monitor Settings Figure 1-2: "Hot Keys" 1. Auto-adjust "hot key": Press button 2 to apply the monitor setting automatically. A small "Auto Adjust" OSD is also displayed. Contrast-adjust "hot key": Press button 3 to allow you to adjust the contrast of the display directly. A small "Contrast" OSD is also displayed. 4 C. The LCD Monitor -- Rear View Figure 1-3: LCD Monitor Rear View 1. VGA Cable With 15-Pin D-Sub VGA Connector Adjusting the Tilting Angle The LCD monitor's angle settings range from -5° to 25°. Figure 1-4: Tilting the Monitor 5 Connecting AC Power and Video Cable Turn off your PC and the LCD monitor before connecting your LCD monitor to the computer. Figure 1-5: The AC Adapter Power Management System The LCD monitor complies with the VESA DPMS power management proposal. When the LCD monitor is in power-saving mode or detects an incorrect timing, the monitor screen will be blank and the power LED indicator starts blinking. 6 The Display Controls The LCD Monitor's Control Panel Figure 2-1: The Control Panel 1. OSD Menu button Press this button to display the OSD (On-Screen Display) menu. Function button This button lets you go through the various controls available in the OSD (ex. Adjustment button 1 This button lets you go through the suboptions within a particular OSD control (ex. under "Monitor Control" in the OSD). in H-Position), you can also use this button to increase values. Adjustment button 2 This button lets you adjust the values for a particular suboption (ex. Brightness or Contrast settings under "Graphic Control" in the OSD). in Brightness), you can also use this button to decrease values. Power Switch This button lets you turn power for the LCD monitor ON or OFF. This is also a "hot key" to close the OSD menu while it is on display. 7 Adjusting the Monitor's Display OSD Main Menu To access the OSD main menu, press the OSD Menu button. Use the Function button and the Adjustment buttons to scroll through the various OSD controls. The highlighted OSD control is the one that is currently selected. Pressing the OSD Menu button causes the following screen to appear: Figure 2-2: The OSD Main Menu Auto Adjust Option The Auto Adjust option lets the monitor determine and select the settings that are most appropriate for your system requirements. Monitor-Control Option The Monitor-Control option allows you to adjust the LCD monitor's display settings. H-Position: Moves the LCD monitor's display left or right on a horizontal plane. [. . . ] Signal out of monitor's supported range When the frequency range of the signal is out of the Monitor's specifications, the display will show either of the following messages: The incoming frame rate is higher than 75Hz. In this case, the screen display may not be centered and a warning message appears. Case 2: The incoming resolution is higher than 1024x768. In this case, the video data will be turned off and a warning message appears at center. Case 1: 12 Appendix A TFT LCD Monitor Specifications LCD Panel Control Functions Power On-Screen Display (OSD) 15" XGA Software Power switch with LED indicator (ON/OFF) Main Menu Auto Adjust Monitor Control OSD Control Misc. [. . . ]