User manual MICROTEK GNC M ADF600EL 0700

[. . . ] 160, Paya Lebar Road, 05-04 Orion Industry Building, 409022 Singapore Tel: 65-747-7851 Fax: 65-747-7852 Internet: http://www. microtek. com. sg ii Contents 1 Introduction Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 2 Installation Checkout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Before you Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The Automatic Document Feeder package includes these components: · Automatic Document Feeder · Warranty Card · Automatic Document Feeder Installation and Operation Manual · Spare Guide Flap, 2 sheets Before you Begin Follow these steps before installing the Automatic Document Feeder: 1. Make sure the scanner's back panel has a 15-pin Automatic Document Feeder connector. Call Microtek if your scanner doesn't have one. 15-pin Automatic Document Feeder Connector 2. Install the scanner as described in your Installation Guide. Make sure that the scanner, its peripherals, and the computer are all powered off. Note: The Automatic Document Feeder (ADF) uses the same connector as a Transparency Media Adapter (TMA). If you own a TMA, disconnect the TMA and remove it from the scanner. 2 Automatic Document Feeder Installation and Operation Manual Installation Follow these steps to install the Automatic Document Feeder: 1. Pull out the two pins holding the scanner cover and lift off the cover. Place the Automatic Document Feeder on top of the scanner. Insert the guide pins into the holes originally used by the scanner cover. Note: The Automatic Document Feeder for ScanMaker series scanners has shorter guide pins than other scanner models. Plug the Automatic Document Feeder's connector into the Automatic Document Feeder connector of your scanner. Secure the connector by tightening its retaining screws. After the Automatic Document Feeder is securely attached, swing the paper support up to over 60 degrees. The paper support should stay in the raised position by itself. Press the Locking Button at the right side of Automatic Document Feeder. This will cause the transport module of Automatic Document Feeder to pop up a little. Pressing the Locking Button MICROTEK INTERNATIONAL INC. Automatic Document Feeder Installation and Operation Manual 3 6. Check the transparent guide flap on the base. [. . . ] To prevent printing ink and other contaminants from accumulating on the flap and interfering with image quality, wipe it periodically with a ink-free cloth or swab cotton swab moistened with industrial alcohol. After prolonged use, the surface of the flap may become scratched. This causes lines to appear in scanned images which can create OCR errors. Should the scratches appear, detach the flap, and replace it with a new one. Wiping the Guide Flap with a piece of ink-free cloth Roller Cleaning Prolonged use of the ADF may result in accumulation of ink and other contaminants on the feeder's input roller, reducing the roller's efficiency. [. . . ]