User manual MICROTEK GNC M C586P XXXX

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. · · · Increase the separation between the equipment and the receiver. [. . . ] Please refer to Figure 1-4. Figure 1-4: The AC Adapter 2. Connect the power connector of the adapter into the power jack of the LCD Monitor. The power jack is located at the rear of the Monitor near the USB hub connector. Please refer to Figure 1-5. Figure 1-5: Connecting Power to the LCD Monitor 7 Connecting the Video 1. Connect one end of the VGA signal cable to the PC's D-sub VGA port and the other end to the monitor's VGA port. If your PC has a graphic card with a 24-pin DVI connector, you should connect it to the Digital 24-pin DVI signal cable. Figure 1-6: Connecting the LCD Monitor to the PC 4. Make sure the signal cable heads are securely connected to the VGA port (or DVI port) of your PC and Monitor. Tighten the connecting screws to ensure a secure connection. 5. Turn on your computer and LCD Monitor. 8 Connecting the Stereo Speakers Please refer to the following instructions for connecting the LCD Monitor's stereo speakers. 1. Connect the sound cable to the line-out of your PC's audio card. Connect the other end of the sound cable to the LCD Monitor's line-in jack. PORT-SELECT: Use this option to change input between the VGA port and DVI digital port. EXIT: Use this option to exit the Monitor Control submenu. OSD Control Option The OSD Control option lets you adjust the position of the OSD on the screen. OSD-H-POSITION: Use this option to change the position of the OSD on a horizontal plane. OSD-V- POSITION: Use this option to change the position of the OSD on a vertical plane. OSD-TIMER: Use this option to change the OSD display time. EXIT: Use this option to exit the OSD Control submenu. Graphic Control Option The Graphic Control option lets you make adjustments that affect the contrast, brightness and color of the LCD monitor's display. CONTRAST: Use this option to adjust the difference between the lightest and darkest areas of the LCD monitor's display screen. BRIGHTNESS: Use this option to adjust the level of light on the LCD monitor's display screen. The Brightness level should be adjusted in conjunction with the Contrast item. 12 COLOR: Use this option to select the LCD monitor's color display. The available options are 9300, 6500 and User. The 9300 and 6500 options let you set the Color Temperature to CIE coordinates 9300° or 6500°, respectively. Selecting the user option lets you make individual adjustments to the R, G and B items. R, G and B: Use this option to make individual adjustments to the Red / Blue / Green (RGB) gain for the color temperature. Before adjusting these fields, select the User option in the Color submenu first. [. . . ] Refer to Appendix B for a listing of factory preset modes supported by this LCD Monitor. PROBLEM: Display is Unclear and Unstable To stabilize and clarify your display, follow this procedure in this order: 1. It is best to adjust the display on a screen displaying vertical lines. In Windows, load a wallpaper bitmap that has vertical lines in it (or you can select the Windows shutdown screen). [. . . ]