User manual MICROTEK GNC M C997SD XXXX OLD

[. . . ] C997SD 19" LCD MONITOR USER'S MANUAL i ii FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. [. . . ] The plug on the power cable will vary according to the electrical standard in your area. Please refer to Figure 1-4. Figure 1-4: The AC Adapter 2. Connect the power connector of the adapter into the jack of the LCD Monitor. The DC power jack is located at the rear of the Monitor near the USB Hub connector. Please refer to Figure 1-5. Figure 1-5: Connecting Power to the LCD Monitor 6 Connecting Video 1. Turn off your PC and the LCD Monitor before connecting your LCD Monitor to the computer. Connect one end of the VGA signal cable to the PC's D-sub VGA port and the other end to the monitor VGA port. If your PC has a graphic card with a 24-pin DVI connector, you should connect it with the Digital 24-pin DVI signal cable. Figure 1-6: Connecting the LCD Monitor to the PC 4. Make sure the signal cable heads are securely connected to the VGA port (or DVI port) of your PC and Monitor. Tighten the connecting screws to ensure a secure connection. Turn on your computer and LCD Monitor. 7 Connecting the Stereo Speakers Please refer to the following instructions for connecting the LCD Monitor's stereo speakers. Connect the 1. 5M mini stereo audio cable to the Line out of your PC's audio card. Connect the other end of the 1. 5M sound cable to the LCD Monitor's line-in jack. Please refer to Figure 1-7. Figure 1-7: Connecting the Stereo Speakers 3. You can adjust the sound volume of the stereo speakers by using the speaker volume control function on the OSD (On-Screen Display). Please refer to the next chapter for details. Power Management System The LCD Monitor complies with the VESA DPMS (version 1. 0p) power management proposal. The VESA DPMS proposal provides four phases of power saving modes by detecting the horizontal or vertical sync signal. When the LCD Monitor is in power saving mode or detects an incorrect timing, the Monitor screen will go blank and the power LED indicator will start to blink. 8 The Display Controls The LCD Monitor's Display Controls This chapter covers the LCD Monitor's On Screen Display (OSD). V-Position: Use the Adjustment Control buttons to move the LCD monitor's display up or down on a vertical plane. Phase: Use the Adjustment Control buttons to adjust the focus and clarity of the display. Clock: Use the Adjustment Control buttons to adjust the display pixel number alignment. Reset: Pressing either of the Adjustment Control buttons resets all of the Monitor-Control submenu settings. 10 Port-Select: Press the Adjust buttons to change input between VGA port and DVI digital port (optional). [. . . ] Now press the bottom (or top) Adjustment Control button until the lines disappear and you have a clear display. 17 PROBLEM: There is no LCD Display If there is no display on the LCD, please perform the following steps: 1. Make sure that the power indicator on the LCD Monitor is lit, all connections are secure, and the system is running on the correct timing. Refer to the Addendum for information on timing. Turn off the LCD Monitor and then turn it back on again. [. . . ]