User manual MICROTEK GNC M JTXV7S XXXX

[. . . ] Connect the equipment into an outlet different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit. The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. i CE mark for Class B ITE (Following European standard EN55022/1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1+A2+A3+A4+A11) Radio Frequency Interference Statement Warning: This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures. Canadian Doc Notice For Class B Computing Devices This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian Department of Communications. [. . . ] Brightness or Contrast settings under "Graphic Control" in the OSD). in Brightness), you can also use this button to decrease values. 7 5. Power Switch This button lets you turn power for the LCD monitor ON or OFF. This is also a "hot key" to close the OSD menu while it is on display. 8 Adjusting the Monitor's Display OSD Main Menu To access the OSD main menu, press the OSD Menu button. Use the Function Select buttons to scroll through the various OSD controls. The highlighted OSD control is the one that is currently selected. Analog mode Each main menu and submenu item is covered below. Pressing the OSD Menu button causes the following screen to appear (an example): Figure 2-2: The OSD Main Menu Monitor-Control Option The Monitor-Control option allows you to adjust the LCD monitor's display characteristics. AUTO-ADJUST : Applies automatic monitor settings for optimal viewing. H-POSITION: Moves the LCD monitor's display left or right on a horizontal plane. 9 V- POSITION: Moves the LCD monitor's display up or down on a vertical plane. PHASE: Adjusts the focus and clarity of the display. CLOCK: Adjusts the display's pixel alignment. RESET: Resets the H- Position, V-Position, Phase and Clock parameters. GRAPH. /TEXT: Switches between the text and graphic options. EXIT: Exits the Monitor-Control submenu. OSD-Control Option The OSD-Control option lets you adjust the position of the OSD on the screen. OSD-H-POSITION: Changes the position of the OSD on a horizontal plane. OSD-V- POSITION: Changes the position of the OSD on a vertical plane. OSD-TIMER : Changes the OSD display time. EXIT: Exits the OSD-Control submenu. Graphic-Control Option The Graphic-Control option lets you adjust the contrast, brightness, and color of the LCD monitor's display. 10 CONTRAST: Adjusts the difference between the lightest and darkest areas of the LCD monitor's display screen. BRIGHTNESS: Adjusts the level of light or brightness on the LCD monitor's display screen. Brightness should be adjusted together with Contrast. COLOR: Selects the LCD monitor's color display. The available options are 9300, 6500 and User. [. . . ] If step 2 does not work, connect your PC system to another external CRT. If your PC System functions properly with a CRT Monitor but it does not function with the LCD Monitor, and the LCD Monitor's power LED is blinking, the output timing of the PC's VGA card may be out of the LCD's synchronous range. Please change to an alternate mode listed in Appendix B or replace the VGA card and repeat steps 1 and 2. If the PC does not function with the CRT monitor as well, check the BIOS to see if there is a dual scan setting under the display mode item. [. . . ]