User manual MICROTEK GNC M TIS1-TID1 0703

[. . . ] Copyright© 2003 Microtek International, Inc. All rights reserved Microtek® is a registered trademarks of Microtek International, Inc. Macintosh® and Apple® are registered trademarks of Apple Computer, Inc. Windows® is a registered trademark of Microsoft Corporation. [. . . ] Connect one end of the Video cable to the cameras TVoutput connector. Connect the other end of the cable to the Video In jack of the TV set. NTSC: . or USA, Canada, Mexico, Taiwan, Korea, Japan, etc. PAL: . or Europe, Australia, China, Singapore, etc. Press the MENU button to confirm the setting and exit the menu. 3. Turn on the TV set and switch it to run off Video Input. Set the cameras Mode switch to (Playback). The most recently recorded image appears on the TV monitor. !% Deleting Images Deleting Selected Image If you want to delete a stored image, you must first select the image you want to delete. Use the 4-way arrow buttons to select the image you want to delete. A confirmation screen prompts you to confirm your decision to delete the selected image. Select OK to delete the image, then press the Shutter (OK) button. The selected image is removed from memory and will no longer be available for viewing. Deleting All Images To delete all images: 1. Use the 4-way arrow buttons to select ERASE ALL. You can remove images from the internal camera memory, as well as from the SD card. This allows you to free up memory space in which to store future images. Deleting the Current Image If you are currently viewing an image and decide that you want to remove it: 1. A confirmation screen prompts you to confirm your decision to delete the current image. When selected, the OK?setting appears as well and is highlighted in red, allowing you to erase all images. A confirmation screen appears to allow you to erase all images or to cancel. Use the 4-way arrow buttons to select OK, then press the Shutter (OK) button. All the images are removed from the memory and will no longer be available for viewing. 2. Select OK to delete the image, then press the Shutter (OK) button. !& Audio Recording Audio Audio mode allows you to record audio clips of unlimited length in the WAV file format (limited only by the size of available memory). Set the Mode switch to (Movie/Audio) / The audio standby recording screen appears on the LCD screen. The movie standby recording screen appears on the LCD screen. Use the 4-way arrow buttons to select DRIVE MODE, then select . 5. Press and release the Shutter (OK) button. [. . . ] Make sure one end of the USB cable is connected to your computer and the other end to your cameras USB connector. (See page 48. ) A1: The Mode switch is set to the incorrect mode. A2: The camera is not connected to the computer. Make sure one end of the USB cable is connected to your computer and the other end to your cameras USB connector. [. . . ]