User manual MICROTEK GNC TR FIREWIRE

[. . . ] Troubleshooting Tips for Microtek FireWire Interface Scanner For Windows 98 Second Edition/ 2000 Q1: My computer cannot detect the FireWire card (IEEE 1394) I've just installed. Check the version of your Windows Operating software. [. . . ] See next section. Windows 2000 Windows 98 SE Windows 2000 Windows 98 SE 1 (English) 3. Check whether the FireWire card (IEEE 1394) is properly seated in your computer's PCI slot. a) Turn off your computer, then remove the cover. b) Make sure the FireWire card is seated all the way in and secured into the PCI card slot. If the card is not properly seated, REMOVE, and then REINSERT the FireWire card again. Q2: The FireWire card (IEEE 1394) was found but my scanner cannot be detected by Windows 98 SE. Make sure that only one FireWire cable is connected to your scanner (You can only use one cable/ interface at a time). Connect the scanner's FireWire cable to your computer, plug the power cord into a power source, cord turn turn on the scanner's power (the green light on the front of your scanner should stay on solid), and then re-start your computer. Open the System Properties dialog box by doing the following in succession: Start, Settings Control Proper operties Start Settings, Control Panel, Panel and then double-click the System icon. From the System Properties select the Device Manager tab. Select and double-click [?] 0000D0B9 00B1 IEEE 1394 SBP2 Device Properties to open its Device Proper operties proper operties properties dialog box. On the Driver tab, click the Reinstall Driver button. (English) 2 5. [. . . ] 3 Turn the scanner on and wait until all lights stop blinking and remain solid. If you have followed all the steps above and your Mac OS still cannot find your scanner please visit http://www. apple. com http://www. apple. com for more information about FireWire support on your Macintosh. 3 (English) [. . . ]