User manual MIDLAND TITAN 40-WATT UHF OPERATORS MANUAL

[. . . ] User's Guide TitanTM Series 120/320 Channel VHF-Low Band Mobile 120/320 Channel VHF-High Band Mobile 120/320 Channel UHF-High Band Mobile www. midlandradio. com TitanTM Mobile User's Guide FCC RF EXPOSURE COMPLIANCE REQUIREMENTS FOR OCCUPATIONAL USE ONLY The FCC has adopted a safety standard for human exposure to RF energy. Proper operation of this radio under normal conditions results in user exposure to RF energy below the Occupational Safety and Health Act and Federal Communication Commission limits. Mandatory Safety Instructions to Installers and Users: This radio is NOT approved for use by the general population in an uncontrolled environment. This radio is restricted to occupational use and work related operations only. [. . . ] Pressing the MON button or PTT will disable the 2-tone muting function. Consult your dealer or communications coordinator for further details on how your radio has been programmed for 2-tone operation. 14 © 2005, Midland Radio Corporation TitanTM Mobile User's Guide 2-tone signaling allows users to receive only calls intended for them. However, more than one radio transmitting at a time will still cause interference. Wait until the channel is clear before transmitting. Transmitting to Other Radios Before transmitting, the FCC requires you monitor the channel to make sure it is clear. Transmitting while someone else is transmitting will create interference and disrupt both conversations. Follow these steps to transmit to other radios. 1. Monitor the channel by pressing the MON button. Channel activity is also indicated by the BUSY icon. If the channel is clear, press and hold the push to talk (PTT) switch on the side of the microphone. The TX icon will display while the radio is transmitting. Hold the microphone approximately 2 inches from your mouth and speak across the face of the microphone in a clear, normal voice. Keep the PTT switch pressed until you have finished speaking. Release the PTT switch to return to receive mode. Press PTT before you start talking and release PTT after you have finished speaking. Your radio doesn't allow you to talk and receive simultaneously, so keep your transmission short. When you are transmitting, other people can not. Use common sense and do not occupy the channel too much. The radio might be programmed with a timeout timer which will automatically end your transmission after a preset time. In this case release PTT and wait for a few seconds. The radio transmitter will be enabled again after a few seconds. Ask your dealer or communications coordinator for further details. The radio might be programmed for busy channel lock out, which automatically disables the transmitter if your channel is busy. In this case wait until the channel is clear. © 2005, Midland Radio Corporation 15 TitanTM Mobile User's Guide Scanning Channels If you have more than one channel programmed, your Titan radio may be programmed to allow you to scan them. Press and release the SCAN button to activate scan. [. . . ] The Warranty period begins on the date of purchase from an Authorized Midland Sales and Service Outlet. This Warranty is offered to the original end user and is not assignable or transferable. Midland is not responsible for any ancillary equipment attached to or used in conjunction with Midland products. Midland offers to the original end user a Two (2) Year Limited Warranty on Midland Business and Industrial radio products. [. . . ]