User manual MIELE B890

[. . . ] Operating instructions Rotary iron B 890 To prevent accidents and machine damage, read these instructions before Installation or use. UV M. -Nr. 05 319 324 2 Contents IMPORTANT SAFETY INSTRUCTIONS . 32 3 IMPORTANT SAFETY INSTRUCTIONS Read the operating instructions carefully before using this appliance for the first time. They contain important information about the safety, use and maintenance of the appliance. [. . . ] skirts (round). ^ Then turn the roller by hand, always keeping your hands away from the heater plate, so that the edge of the item to be ironed can be held by the heater plate. ^ Press down the foot pedal. ^ Lift the feed board out of the right hand holder and then pull it out to the left of the roller. Laundry bar Ironed laundry can be hung over the swing out bar to avoid creasing. , Take care not to press down on the bar when it is swung out, this could cause the rotary iron to tip over. 17 Ironing Ironing tips ­ To avoid creasing stop the roller, pull the item back slightly and smooth out. If necessary, dampen again with a wet cloth or spray bottle. ­ If possible, always use the whole length of the roller, otherwise the roller will lose its elasticity. ­ For small items such as handkerchiefs, alternate between using the right and left hand sides of the roller. ­ Items with raised buttons should be ironed face down on to the roller so that they are pressed into the cushioned surface. ­ Cover zippers, metal buttons, and metal hooks with a cloth to protect the heater plate. ­ To protect the heater plate do not iron buttons that are not heat resistant or very large. ­ When you have nearly finished ironing you can turn the temperature selector to " g " cold and continue ironing small items with residual heat. After ironing ^ Turn the appliance off. ^ Turn the temperature to " g " cold. If the rotary iron is to be stored away ^ Allow the heater plate to cool. ^ When the heater plate has cooled completely, fold the rotary iron. ^ Pull the cover on. 18 Ironing Power failure In the event of a power failure, pull the emergency release lever up. If there is a power failure when the rotary iron is in use, the heater plate will stay on the roller. The item being ironed will be held there possibly becoming scorched. To free the trapped item ^ Pull the emergency release lever up. The pressure is reduced and the item can be removed. ^ When power has been restored (the indicator in the On/Off switch comes on) push the emergency release lever back down. Continue ironing as usual. 19 Ironing Tips Tablecloths ^ Avoid folds by ironing the middle first. Napkins, hand towels ^ Lay the item with the straight grain of the fabric to the feed board. This will prevent it from loosing its shape and will be easier to fold. Pass handkerchiefs diagonally through the rotary iron and, if necessary, fold them and then iron again. [. . . ] This tends to happen when ironing Continue ironing, the issue is usually delicate items with a new machine. New iron cover A new rotary iron cover should be washed at 140°F (60°C) for the laundry to be ideally pulled in. Clean with household cleaners or dishwasher detergent. Lime or starch deposits on the heater plate. Creases/Folds occur The heater plate is soiled (lime deposits). Clean the heater plate with household cleaners or dishwasher detergent. The rotary iron cover is heavily soiled. [. . . ]