User manual MIELE G 4205

[. . . ] Operating Instructions Dishwasher G 4205 To prevent accidents and appliance damage read these instructions before installation or use. en - US, CA M. -Nr. 07 909 160 Contents IMPORTANT SAFETY INSTRUCTIONS. 13 Items not recommended for dishwashing . 27 Preparing your appliance for an extended vacation . [. . . ] To rinse dishes when a complete program is not needed. X Normal as required X X X X Economy X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 28 Additional options Default settings All settings can be reset to the factory default. ^ Turn the dishwasher off "s". ^ Press the "Start/Stop" button and at the same time turn the dishwasher on "s". Hold the "Start/Stop" button until the "Start/Stop" indicator comes on. ^ Press the "Program" button 12 times. The bottom program indicator flashes once long and twice short in intervals. The "Cleaning" indicator shows if a setting was changed. ­ The "Cleaning" indicator flashes: All settings are the factory default. ­ The "Cleaning" indicator is off: At least one setting was changed. ^ To reset the dishwasher to the default settings, press the "Start/Stop" button. ^ Turn the dishwasher off "s". 29 Frequently asked questions , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage. Technical faults Problem The Start / Stop indicator does not flash after the dishwasher is turned on with "s". The program cycle indicators "Cleaning", "Drying" and "End" flash at the same time. Possible fault The machine is not plugged in. See data plate for minimum amperage. The fuse has tripped. The drain pump is running when the door is open. There may be a technical ­ Turn the dishwasher off fault. After a few seconds: ­ Turn the dishwasher on "s". ­ Select the desired program with the "Program" button. ­ Press the "Start / Stop" button. If the problem persists, contact Technical Service. ­ Turn off the water The waterproof system supply. ­ Contact Miele Technical Service. 30 Frequently asked questions Problems water Intake / Drain Problem The "Intake / Drain" indicator flashes. The "Intake / Drain" indicator flashes. [. . . ] This allows for connection of the machine to either a hot (max. 140°F / 60°C) or cold water source. For lowest energy consumption and fastest possible wash times connect the dishwasher to a hot water source. All programs use hot water in the rinse cycles. [. . . ]