User manual MIELE DA 289-4

[. . . ] Operating and installation instructions Cooker hood DA 289-4, DA 289-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 783 600 Contents Caring for the environment . 15 Reading the filter operating hours counter . 22 Safety distance between hob and cooker hood (S) . [. . . ] The vapour plate and the grease filter must then be cleaned. Afterwards, the filter operating hours counter must be reset. ^ To do this, press and hold the grease filter control for about 3 seconds. The indicator lamp for the control will go out. The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. Reading the filter operating hours counter To check the percentage of time set already used: ^ Press the On/Off control to switch the fan on. ^ Press the grease filter control. 15 Operation Filter operating hours counter The operating hours counter for the grease filters is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose from 20, 30, 40 or 50 hours. ­ Select a short time if you roast or fry a lot. ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally, we recommend that you select a short time because grease which has built up gradually over a long period of time will harden on the grease filter and make cleaning more difficult. The ­ / + control lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the ­ / + controls to select the desired time. ^ Confirm the selection by pressing the grease filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the On/Off control to switch the fan off. ^ Press the run-on option control and the grease filter control at the same time. The indicator light for the grease filter control and one of the lights for the ­ / + controls will flash. 16 Cleaning and care Do not use: Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the wall socket and the plug withdrawn, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents e. g. powder cleaners or cream cleaners, and abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. To help prevent re-soiling, a proprietary conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. Follow the manufacturer's instructions, and apply sparingly with an even pressure in the direction of the "grain". Important for appliances with lacquered housing (special order finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen. Housing General notes The surfaces and controls are susceptible to scratches and abrasions. [. . . ] Important U. K. , IRL, NZ, ZA: This appliance is supplied for connection to an a. c. AUS: This appliance is supplied for connection to an a. c. single phase 240 V, 50 Hz supply. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE EARTHED Operation with Control module DSM 400 The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance. [. . . ]