User manual MIELE DA 3060

[. . . ] Operating and installation instructions Cooker hood DA 3060 To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 681 520 Contents Caring for the environment . 14 Fitting and replacing the charcoal filter . 18 Positioning the appliance in the wall housing unit . [. . . ] ^ Then pull the filter downwards to remove. To avoid damaging the filter or the hob below, make sure you hold the filter securely at all times when handling it. ^ Slide the switch for the fan to position "0". ^ Clean the filter ­ by hand: with a soft nylon brush, warm water and a little washing up liquid. ­ in a dishwasher: place filter upright in the lower basket, and wash on a 65°C programme, ensuring that the spray arm is not obstructed. Grease filter The re-usable metal grease filter in the appliance removes solid particles from the kitchen vapours (grease, dust, etc) preventing soiling of the cooker hood. To avoid a build-up of fat, it should be cleaned every 3-4 weeks on average, but sooner if necessary. An oversaturated filter is a fire hazard. 14 Cleaning and care Depending on the cleaning agent used, cleaning the grease filter in a dishwasher can cause permanent discolouration to the surface. However, this will not affect the functioning of the filter in any way. ^ After cleaning, leave the filter to dry for a while on an absorbent surface before putting it back in place. ^ When removing the filter for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. Fitting and replacing the charcoal filter If the cooker hood is connected for recirculation, a charcoal filter (optional accessory) must be inserted in addition to the grease filter. This is designed to absorb cooking smells. It is fitted in the canopy above the grease filter. Replacement charcoal filters can be obtained from your dealer or the Miele Spare Parts department. See back cover for contact details, and "Technical data" for type and reference number. ^ When putting it back, make sure that the red plastic guides are at the front and facing upwards. ^ Replace the grease filter in the front of the deflector plate, press it upwards and push it in together with the deflector plate. It will slide onto the fixing pins at the back. Finally, push the grease filter back a little more. Follow the instructions supplied with the charcoal filter when fitting it. Replace the charcoal filter at least every six months or more frequently if necessary. Used charcoal filters can be disposed of with the normal household waste. 15 Cleaning and care Changing a halogen lamp ^ Pull out the deflector plate, and remove the grease filter as described earlier. Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off. Do not touch the surface directly when changing a lamp, as grease particles from your fingers will adhere to the surface and damage it. [. . . ] On extraction models, it can be fitted nearest the ducting outlet to the outside to reduce neighbourhood noise, and on recirculation models it can be fitted in between the fan and the canopy. Condensate trap (optional extra) In addition to insulating the exhaust ducting, we recommend that a suitable condensate trap is also installed to collect and evaporate any condensate which may occur. Condensate traps are available for C 125 mm or C 150 mm ducting. When installing a condensate trap, ensure that it is positioned vertically and if possible directly above the exhaust connection. The arrow on the housing indicates the direction of air-flow. 29 Electrical connection be provided for all poles. [. . . ]