User manual MIELE DA 430-4

[. . . ] Operating and installation instructions Cooker hood DA 430-4 DA 430-4 EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 748 870 Contents Caring for the environment . 17 Important for appliances with stainless steel housing . 24 Safety distance between hob and cooker hood. [. . . ] The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 15 Operation Altering the filter operating hours counter The operating hours counter for the grease filter is set at the factory for 30 hours. The time set can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours. The ­ /+ indicator lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the ­ /+ controls to select the desired time. ­ Select a short time if you roast or fry a lot. ­ If you use very little fat for cooking, select a longer time. ­ If you only cook occasionally we recommend that you still select a short time, because grease which has built up gradually over a long period of time will harden on the grease filters and make cleaning more difficult. ^ Press the On/Off control to switch the fan off. ^ Confirm the selection by pressing the grease filter control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the run-on option control and the grease filter control at the same time. The indicator lamp for the grease filter control and one of the ­ / + indicator lamps will flash. 16 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: - it is switched off at the isolator, or - the fuse is withdrawn from the fused spur connection unit, or - the mains fuse is disconnected, or - the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. Please observe the instructions below for cleaning stainless steel, aluminium and glass surfaces and the controls. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. Do not use: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents, e. g. powder cleaners or cream cleaners and abrasive sponges, as well as pot scourers or sponges which have been used previously with abrasive cleaning agents. To help prevent re-soiling, a conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. Follow the manufacturer's instructions. Housing General notes The surfaces and controls are susceptible to scratches and abrasions. Please observe the following cleaning instructions. ^ All external surfaces and controls can be cleaned using a Miele E-Cloth, or with warm water and a little washing-up liquid applied with a well wrung-out soft sponge or cloth. ^ Wipe the surfaces dry using a soft cloth. 17 Cleaning and care Dismantling the decor inserts The decor inserts can be removed to make it easier to clean the canopy. [. . . ] For extra safety it is advisable to install a residual current device (RCD) with a trip current of 30 mA. Important U. K. , IRL, NZ, ZA: This appliance is supplied for connection to an a. c. AUS: This appliance is supplied for connection to an a. c. single phase 240 V, 50 Hz supply. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE EARTHED 28 Operation with DSM 400 control module The Miele DSM 400 control module can be used to combine the cooker hood with other components. [. . . ]