User manual MIELE DA 239-3

[. . . ] Operating and Installation Instructions Ventilation System DA 239-3 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 853 540 2 Contents IMPORTANT SAFETY INSTRUCTIONS Guide to the appliance Functional description Operation Main power switch . 13 Reprogramming the grease filter timer . 14 Cleaning and Care Cleaning the casing . [. . . ] powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. , Never use abrasive cleaners, 15 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). ^ Clean the filters - by hand: use a scrub brush in warm water with a mild detergent. - in a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filters can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ After returning the grease filters, press the grease filter button for 3 seconds to reset the timer. ^ If the grease filters are cleaned before the grease filter timer has reached its maximum, the grease filter button should be pressed for 6 seconds to reset the counter to zero. The grease filters should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. A dirty filter is a fire hazard. ^ To remove the grease filters press the locking clips in towards the middle of the filter. Holding carefully, lower and remove the filter. 16 Cleaning and Care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. To change a bulb: When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool down. Fingerprints or body oils deposited on the bulb will decrease the life of the bulb. Please follow the bulb manufacturer's instructions. ^ Support the glass, c, while detaching the circlip, b. Be careful not to let the glass fall out. ^ Pull the old bulb, d, out of its socket and replace it with a new one. [. . . ] Turn the screw clockwise to raise the canopy and counter-clockwise to lower it. Tighten as much as necessary to level the front of the canopy. ^ Return the grease filters. ^ Remove the grease filters. ^ Before using the appliance remove the grease filter and remove the protective foil from the filter frame. Return the filter. 34 Air extraction , WARNING Danger of toxic fumes. [. . . ]