User manual MIELE DA 250

[. . . ] Operating and Installation Instructions Ventilation System DA 250 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 907 810 Contents IMPORTANT SAFETY INSTRUCTIONS . 12 Reprograming the grease filter timer . 30 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. [. . . ] Factors such as narrow duct diameter and bends will affect this value. Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 operates at 100% capacity 10 Operation Turning off the fan Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. ^ Press the On/Off button to turn off the fan. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was activated. ^ Press the On/Off button to turn the fan back on again. ^ Press the light button briefly to turn on the lighting. ^ Press the light button briefly again to turn off the lighting. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 13 Cleaning and care Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. , Never use abrasive cleaners, 14 Cleaning and care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc. ). ^ Clean the filters, - by hand: use a scrub brush in warm water with a mild detergent. - in a dishwasher: place the filters in the lower basket, making sure that the spray arm is not blocked. The grease filters should be cleaned every 3-4 weeks or whenever the grease filter timer indicator lights. A dirty filter is a fire hazard. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. [. . . ] If installed correctly, the cover should be secure and flush against the ceiling. ^ Before using the appliance remove the grease filter and remove the protective film from the filter frame. Insert the filter. 28 Air extraction Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. The exhaust gases extracted by the hood should be vented outside of the building only. [. . . ]