User manual MIELE DA 279-4

[. . . ] Operating and installation instructions Cooker hood DA 279-4 DA 279-4 EXT DA 279-4 Alu DA 279-4 Alu EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M. -Nr. 06 783 590 Contents Caring for the environment . 31 Operation with Control module DSM 400 . 32 Connection to a window contact switch . [. . . ] The time set can be lengthened or shortened: you can choose 20, 30, 40 or 50 hours. The ­ / + indicator lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the ­ / + touch controls to select the desired time. ^ Confirm the selection by pressing the grease filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press the On/Off control to switch the fan off. ^ Press the run-on option touch control and the grease filter touch control at the same time. The indicator lamp for the grease filter touch control and one of the ­ / + indicator lamps will flash. 16 Operation Activating and altering the operating hours counter for the charcoal filter (in recirculation mode) The charcoal filter is needed for recirculation mode. On delivery, the operating hours counter for the charcoal filter is switched off, For recirculation mode, the operating hours counter needs to be set to suit the type of cooking you do: ^ Confirm the selection by pressing the charcoal filter touch control. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Use the ­ / + controls to select the desired time. ^ Press the On/Off touch control to switch the fan off. Resetting the operating hours counter for the charcoal filter ^ Press the run-on option and the charcoal filter touch controls at the same time. The indicator lamp for the charcoal filter control and one of the lamps above the ­ / + controls will flash. The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one. Afterwards, the filter operating hours counter must be reset. The ­ / + control lamps show the time which has been set: 1st lamp from the left = 120 hours 2nd lamp from the left = 180 hours 3rd lamp from the left = 240 hours 4th lamp from the left = deactivated ^ Press and hold the charcoal filter touch control for about 3 seconds while the fan is switched on. The indicator lamp for the charcoal filter touch control will go out. 17 Operation Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Press the On/Off touch control to switch the fan on. ^ Press and hold the charcoal filter touch control in. One or more of the indicator lamps for the ­ / + touch controls will flash. The number of flashing lamps shows the percentage of the operating time which has already been used up. 1 lamp 2 lamps 3 lamps 4 lamps = 25 % = 50 % = 75 % = 100 % The number of operating hours used remains in the memory, even when the appliance is switched off or there is a power cut. 18 Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: ­ it is switched off at the wall socket and the plug is withdrawn, or ­ the fuse is withdrawn from the fused spur connection unit, or ­ the mains fuse is withdrawn, or ­ the screw-out fuse is removed (in countries where this is applicable). E-Cloth ^ A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Do not use: ­ cleaning agents containing soda, acids, chlorides or solvents, ­ abrasive cleaning agents e. g. powder cleaners or cream cleaners, and abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. Important for appliances with stainless steel housing (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth or with a proprietary non-abrasive cleaning agent designed specifically for use on stainless steel. To help prevent re-soiling, a proprietary conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department) can also be used. [. . . ] It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance. Once connnected, the cooker hood can only be operated when the window is sufficiently open (see also "Warning and Safety instructions"). When the window is closed the cooker hood fan cannot be switched on. The indicator lamp for the On/Off touch control on the cooker hood will flash. [. . . ]