User manual MIELE DA 289-3

[. . . ] Operating and installation instructions Ventilation System DA 289-3 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 853 730 Table of contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the hood Operation Main power switch . 12 Reprogramming the grease filter timer . 13 Cleaning and care Grease filter and air intake panel. [. . . ] ^ Press the Delayed Shut Down button while the fan is still running. Press once = 5 minute delay (left indicator lights) Press twice = 15 minute delay (right indicator lights) To cancel the Delayed Shut Down feature press the button again. ^ Press the light button briefly again to turn off the lighting. The light button indicator will go out. Dimming the lighting The brightness of the lighting can be adjusted. ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. ^ Press the light button again to turn off the lighting. Turning off the fan ^ Press the On/Off button to turn the fan off. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was activated. The lighting however will remain on. ^ Press the On/Off button to turn the fan back on again. 11 Operation Grease filter timer A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filter and air intake panel must then be cleaned. After the grease filter has been cleaned and put in place, the grease filter timer must be reset. Checking the grease filter timer To check the percentage of time already used: ^ Press the On/Off button to turn the fan on. ^ To do this, press the grease filter button for about 3 seconds. - in a dishwasher: place the filters in the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, cleaning the grease filter in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filter can be placed on a towel to air dry. ^ Clean the air intake panel according to "Cleaning the casing". ^ While the filter and the air intake panel are removed, clean any dirt or grease from the interior casing to prevent the risk of fire. ^ Hook the air intake panel on the latches and push a little to the left. [. . . ] If there is more than one appliance beneath the hood and they have different minimum safety distances always select the greater distance. See "IMPORTANT SAFETY INSTRUCTIONS" for further information. 27 Installation Installation instruction See the enclosed installation instruction sheet. Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Dismantling If the hood needs to be disassembled, follow the instructions on the installation sheet in reverse order. A lever is enclosed for easier removal of the chimney extension. Protective film The casing is covered by a protective film to prevent scratches during transport. [. . . ]