User manual MIELE DA 270 U

[. . . ] Operating and Installation Instructions Ventilation System DA 270 U To prevent accidents and machine damage, read these instructions before installation or use. U M. -Nr. 05 907 840 Contents Contents IMPORTANT SAFETY INSTRUCTIONS . 21 2 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. [. . . ] Intensive setting Level "4" (yellow indicator) should be used for a short period when frying or cooking food with a strong aroma. Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this value. Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 operates at 100% capacity Press twice = 15 minute delay (left indicator lights) To cancel the Delayed Shut Down feature press the button again. Turning off the fan ^ Press the On/Off button to turn off the fan. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was activated. ^ Press the On/Off button to turn the fan back on again. 10 Operation Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. Dimming the lighting The brightness of the lighting can be adjusted. ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn on the lighting. ­ A time of 20 hours should also be programmed if the kitchen is only used occasionally. Otherwise grease which has accumulated over a long period of time will harden on the filters making cleaning more difficult. Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. The indicator for the grease filter and one of the _ indicators will flash. The lit _ indicator shows the programmed time: 1st indicator from the left = 20 hours 2nd indicator from the left = 30 hours 3rd indicator from the left = 40 hours 4th indicator from the left = 50 hours ^ Use the $ or & button to select the desired time. ^ Store the selection by pressing the grease filter button. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. ^ Press the On/Off button to turn off the fan. ^ Press the Delayed Shut Down and the grease filter buttons at the same time. 13 Operation Reprogramming the active charcoal filter timer The active charcoal filter can only be used in recirculation mode and can not be used to exhaust fumes. The active charcoal filter timer is not preset. Before using the hood in recirculation mode, the active charcoal filter timer must be programmed. The indicator for the active charcoal filter and one of the _ indicators will flash. The lit _ indicator shows the programmed time: 1st indicator from the left = 20 hours 2nd indicator from the left = 30 hours 3rd indicator from the left = 40 hours 4th indicator from the left = 50 hours ^ Use the _ button to select the desired time. ^ Press the On/Off button to turn off the fan. ^ Store the selection by pressing the active charcoal filter button. ^ Press the Delayed Shut Down and active charcoal filter buttons at the same time. If the procedure is not stored within 4 minutes of programming, the hood will automatically default to the "old" data. 14 Cleaning and Care Stainless steel Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. [. . . ] 15 A 25 Appliance dimensions a Mounting bolt holes; screws 8 mm diameter b Cut out power cord 26 Installation Do not install this exhaust hood over cooktops burning solid fuel. When installing the hood, make sure that the following minimum safety distances (S) between the top of a Miele cooking surface and the bottom of the hood is: - 22" (55 cm) above electric cooktops - 26" (65 cm) above gas cooktops - 26" (65 cm) above an open grill For non-Miele cooking appliances maintain the safety distances recommended by the cooktop manufacturer in their installation and operating instructions. If there is more than one appliance beneath the hood and they have different minimum safety distances always select the greater distance. See "Important Safety Instructions" for further information. [. . . ]