User manual MIELE DA289-4 VENTILATION SYSTEM

[. . . ] Operating and Installation Instructions Ventilation System DA 289-4 To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 06 713 850 Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the hood Operation Turning on the fan . 14 Cleaning and care Cleaning the casing . 19 After Sales Service Installation instructions Caring for the environment Installation accessories Plywood backing Electrical data Appliance dimensions Installation Installation instructions . [. . . ] The light button indicator will go out. ^ If the button is pressed again, the lighting will brighten until the button is released. If the button is pressed continuously, the light will cycle between bright and dark. ^ Press the light button again to turn off the lighting. 13 Operation Grease filter timer A timer monitors the hours of fan operation. Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing , Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface. ^ The air intake panel, exterior surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Only use a slightly damp sponge when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents, ­ limescale removers. These will damage the surface. 16 Cleaning and care Grease filter and air intake panel The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). Removing the air intake panel The grease filter and the air intake panel should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. Keep the grease filter clean to prevent a fire hazard. ^ To remove the air intake panel gently pull out and downward, shifting the lower part a bit to the right. Support the air intake panel so that it does not fall onto the cooktop. Removing the grease filter ^ To remove the grease filter, pull on the lever. Support the grease filter so that it does not fall onto the cooktop. 17 Cleaning and care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggessive all purpose cleaners, oven sprays or limescale removers. ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. [. . . ] Standard unit height H 37 7/8" - 51 7/8" (960 - 1320 mm) 29 Installation Installation instructions ^ See the enclosed installation instruction sheet. ^ Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Dismantling If the hood needs to be disassembled, follow the instructions on the installation sheet in the reverse order. A lever is enclosed for easier removal of the chimney extension. Protective film The casing is covered with a protective film to prevent scratching during transport. ^ Peel off the film before installing the casing parts. ^ After removing the screws from the chimney, slide the lever between the chimney and the chimney extension and gently apply pressure to ease the chimney from its hooks. 30 Air extraction , WARNING Danger of toxic fumes. [. . . ]