User manual MIELE DA 289

[. . . ] Operating and Installation Instructions Ventilation System DA 289-4 To prevent accidents and appliance damage, read these instructions before installation or use. en - US M. -Nr. 07 782 280 Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the Ventilation System Operation Turning on the fan . 14 Cleaning and care Cleaning the casing . 19 After Sales Service Installation instructions Caring for the environment Appliance dimensions Installation accessories Plywood backing Installation Dismantling . [. . . ] To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. , Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface. ^ The air intake panel, exterior surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Only use a slightly damp sponge when cleaning the controls. Water could penetrate into the electronics and cause damage. ^ Glass surfaces can be cleaned using glass cleaner. 16 Cleaning and care Grease filter and air intake panel The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). Removing the air intake panel The grease filter and the air intake panel should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. , A dirty filter is a fire hazard. ^ To remove the air intake panel gently pull out and downward, shifting the lower part a bit to the right. Support the air intake panel so that it does not fall onto the cooktop. Removing the grease filter ^ To remove the grease filter, pull on the lever. Support the grease filter so that it does not fall onto the cooktop. 17 Cleaning and care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays or limescale removers. ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. In a Miele dishwasher use the "Normal" program. Use the recommended amount of dishwasher detergent. Depending on the detergent, cleaning the grease filter in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filter can be placed on a towel to air dry. ^ Clean the air intake panel according to "Cleaning the casing". ^ While the filter and the air intake panel are removed, clean any dirt or grease from the interior casing to prevent the risk of fire. ^ Push the grease filter back in place. ^ Hook the air intake panel on the latches and push a little to the left. Push it toward the unit so that it clicks in place. [. . . ] ­ The exhaust duct must not be bent or compressed. ­ Make sure all connections are secure. ­ Where the ductwork is horizontal, it must slope away from the hood at least 1/8" per foot (1 cm per meter) to prevent condensation dripping into the appliance. ­ If the exhaust is ducted through an outside wall, a Telescopic Wall Vent can be used. 30 Air extraction Condensate trap optional accessory In some cases, a condensate trap may also be required to collect and evaporate any condensate which may occur. [. . . ]