User manual MIELE DA 399-5

[. . . ] Operating and Installation Instructions Ventilation System DA 398-5 DA 399-5 To prevent accidents and appliance damage, read these instructions before installation or use. en - US M. -Nr. 07 759 400 2 Contents IMPORTANT SAFETY INSTRUCTIONS. 33 3 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. [. . . ] Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filter can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing. , A dirty filter is a fire hazard. ^ To remove the grease filter pull the locking clips forward, lower the filter down 45°, unhook it at the rear, and take it out. Support the grease filter so that it does not fall and damage the cooktop. 14 Cleaning and Care When putting the grease filters back make sure that the locking clips are visibly facing the cooking surface Active charcoal filter In recirculation mode an active charcoal filter must be used in addition to the grease filters. The active charcoal filter will be replaced in the canopy above the grease filters. Replacement active charcoal filters can be ordered from Miele. ^ If the filters are incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. ^ To install or replace the charcoal filter, the grease filters must first be removed as described in the previous section. ^ Remove the charcoal filter from the packaging. ^ Slide the charcoal filter into the rear of the filter frame, then raise the front up and push it into the frame. Replace the active charcoal filter at least every 6 months or when they no longer absorb odors efficiently. ^ Used charcoal filters may be discarded in household trash. 15 Cleaning and Care Changing the light bulb , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions". ^ Remove the grease filters. ^ Turn the knurled screw counterclockwise. The halogen lamp will swivel down. When in use halogen bulbs become extremely hot, use caution. Do not attempt to change the bulbs until they have had sufficient time to cool. Fingerprints or body oils deposited on the bulb will decrease its life. Follow the bulb manufacturer's instructions. ^ Turn the bulb counterclockwise and pull it out of its socket. Use the same bulb type as a replacement: GU/GZ10, 120V, 50W. ^ Replace the bulb with a new one in the reverse order. ^ Replace the grease filters. 16 After Sales Service Repairs In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department. ^ When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filters are removed. MieleCare (USA only) MieleCare, our Extended Service Contract program, gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability, and longevity of your Miele appliance. Please note that unless expressly approved in writing by Miele's Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. [. . . ] Important The hood comes equipped with a 4 ft (1. 2 m) power cord with a NEMA 5-15 molded plug for connection to a 120 V, 60 Hz, 15 A power outlet. WARNING: THIS APPLIANCE MUST BE GROUNDED 30 Air extraction , WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Do not vent exhaust air into spaces within walls or ceilings or in attics, crawl spaces or garages. [. . . ]