User manual MIELE DA 5321 W

[. . . ] Operating and Installation Instructions Ventilation System DA 5321 W DA 5381 W DA 5391 W To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 07 901 910 Contents IMPORTANT SAFETY INSTRUCTIONS. 36 2 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. [. . . ] These will damage the surface. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. Do not use too much water when cleaning the controls. Water could penetrate the electronics and cause damage. ^ Glass surfaces can be cleaned using a glass cleaner. The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can be applied. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. 17 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. In a Miele dishwasher use the "Normal" program. Use the recommended amount of dishwasher detergent. Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filters can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. ^ To remove the grease filters pull the locking clips, 1, forward. Lower the filter 45°, 2, unhook it at the rear, 3, and take it out. Support the grease filter so that it does not fall onto the cooktop. Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. 18 The grease filters should be cleaned every 3 - 4 weeks or when the grease filter indicator lights. , A dirty filter is a fire hazard. When putting the grease filters back make sure that the locking clips are visibly facing the cooking surface. [. . . ] ­ If the exhaust is ducted through an outside wall, a Telescopic Wall Vent can be used. 33 Air extraction Condensate trap optional accessory ­ If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. Important If the ductwork runs through rooms, ceilings, garages, etc. [. . . ]