User manual MIELE DA 6490

[. . . ] Operating and Installation Instructions Downdraft Ventilation System DA 6480, DA 6490 DAG 500, DAG 1000 To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M. -Nr. 09 045 140 Contents IMPORTANT SAFETY INSTRUCTIONS. 10 Raising the vent / Turning on the fan . 26 Installation with the DAG 1000 external blower . [. . . ] They have been designed to be biodegradable and recyclable. Please recycle. Disposal of an old appliance Old appliances may contain materials that can be recycled. Please contact your local recycling center about the possibility of recycling these materials. Before discarding an old appliance, disconnect it from the electrical supply and cut off the power cord to prevent it from becoming a hazard. Ensure that any plastic wrappings, bags, etc. , are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation! , DANGER 19 Appliance dimensions 20 Appliance dimensions a DAG 500 Internal blower The blower box can be mounted in such a way that the vent collar is aligned to the left, the right, downwards or towards the rear, as desired. b Connection plate when using the DAG 1000 external blower The blower or the connection plate can also be mounted in the same position on the rear of the appliance. x = Distance to the rear of the cabinet or wall. Must be a minimum of ½" (13 mm). Exhaust duct connection diameters DA 6480, 6490 with internal blower DAG 500:. 6" C (150 mm) DA 6480, 6490 with external blower DAG 1000: . 10" C (254 mm) 21 Appliance dimensions Cabinet dimensions 22 Appliance dimensions Exhaust air ducting using the DAG 500 internal blower, installed on the front of the appliance [vent duct 6" C (150 mm)]: a to the left or right, b downwards, c to the rear. If the blower is being installed at the rear of the appliance, a cut-out must be made in the rear of the cabinet or wall where it will be mounted and the appropriate clearances must be maintained behind the cabinet. d Feed the power cord and control cable when using an external blower downwards or to the rear. e Using the DAG 1000 external blower, install exhaust ducting to the rear (vent duct 10" C (254 mm)). If installing the exhaust ducting to the front, appropriate clearances must be maintained in the cabinet. a) Cooktop overhang b) Minimum width of the cooktop: DA 6480: 28" (711 mm) DA 6490: 34" (864 mm) ­ The specified dimensions minimum cut-out dimensions must be observed. ­ If an oven or stove is installed before the ventilation system, read the associated installation instructions. Note all installation dimensions and guidelines regarding ventilation systems. ­ Be aware of kitchen cabinets, back splashes and/or racks in the area of the ventilation system and the cooktop. Ensure that the area where the vent rises is free of obstacles. ­ Make sure that any required minimum distance between the front edge of the countertop and the front edge of the cooktop is maintained. ­ If there is a drawer in the way, it must be shortened or removed. [. . . ] This optional accessory is available for ducts 5" (125 mm) and 6" (150 mm) in diameter. ^ When installing a condensate trap, ensure that it is positioned vertically and if possible directly above the exhaust outlet. (optional accessory for interior-mounted vent motor) ^ Push the Reducing Collar on the exhaust port of the fan. ^ Fix both with a hose clamp. 36 Electrical connection , WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: All electrical work should be performed by a qualified electrician in strict accordance with national regulations and local safety regulations. [. . . ]