User manual MIELE EGW4060-14-PLATE WARMER

[. . . ] Before installation make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond in order to prevent injury and machine damage. If in doubt, consult a qualified technician. The electrical safety of this appliance can only be guaranteed when continuity exists between the appliance and an effective grounding system. [. . . ] Metal components have a protective coating which may give off a slight odor the first time your new appliance is heated. The smell will dissipate after a short time and does not indicate a faulty connection. 7 Use Controls The plate warmer is only intended for warming dishes. Do not use the plate warmer to reheat, cook or keep food and drinks warm. Condensation from food or drinks may cause moisture damage to the appliance. The drawer can hold a maximum of 55 lbs (25 kg). The appliance works with a convection system. A fan distributes the heat evenly throughout the drawer. The air circulation heats the dishes fast and evenly. A protective grill prevents contact with the heating element and fan. The floor of the warming drawer has a non-slip mat to prevent plates and dishes from sliding when the drawer is opened and closed. The controls consists of the temperature selector and the On/Off button. They are only visible when the drawer is open. The indicators at the front show if the plate warmer is turned on or off. 8 Use Operating ^ Place the dishes in the drawer. The drawer may open again if closed too forcefully. ^ Turn the appliance off (k), before removing the warmed dishes. Do not turn the knob counterclockwise or clockwise past the 9 o'clock position. Forcing it beyond these positions will damage the temperature selector. When the selected temperature is reached, the heating element turns off. If the temperature falls below the selected one, the heating element will turn on again. The temperature scale shows symbols for the optimum temperature of the respective dish group: ­ b approx. 105 °F (40 °C) For cups or glasses. 150 °F (60 °C) For serving or eating plates. [. . . ] ^ Align and even the gap with the flat washers by changing their position (above or below the drawer), on both sides. 21 Installation Electrical connection The electrical installation instructions for any appliance installed in combination with the plate warmer must be observed. When another appliance is installed in combination with the plate warmer to the same circuit breaker, operating both appliances at the same time may cause an overload. If in doubt consult a qualified electrician. All electrical work should be done by a qualified technician, in strict accordance with national and local safety regulations. [. . . ]