User manual MIELE EGW 601

[. . . ] Read all operating and installation instructions for any other appliance installed in combination with the plate warmer. Before installation make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent injury and machine damage. Consult a qualified electrician if in doubt. [. . . ] The steam could penetrate electrical components and cause a short circuit. In areas subject to infestation by cockroaches or other vermin, keep the appliance and its surroundings clean at all times. Any damage caused by pests will not be covered by the appliance warranty. Do not use outdoors. Disposal of an old appliance Before discarding an old appliance, disconnect the power cord and remove any doors to prevent hazards. 5 Caring for our environment Disposal of the packing material The transport and protective packing materials are environmentally friendly for disposal and may be recyclable. Ensure that any plastic wrap is disposed of safely and kept out of the reach of babies and young children. Please recycle. Disposal of an old appliance Old appliances contain materials which can be recycled. Please contact your local recycling center about potential recycling. Ensure that the appliance presents no danger to children while waiting for disposal. See the instructions in the "Warning and Safety instructions". 6 Guide to the plate warmer a On/Off button b Temperature control c Warming drawer d Non-slip mat e Rail f On/Off indicator light 7 Using the plate warmer The plate warmer is only intended for warming dishes. Do not use the plate warmer to re-heat, cook or keep food or drinks warm. Condensation from food or drinks could cause moisture damage to the appliance. The appliance operates with a hot air system. A fan distributes hot air to heat plates quickly and evenly. A protective grill prevents any contact with the heating element and fan. The rail in the drawer separates the control panel, heating element and fan from the rest of the drawer. This prevents plates from being placed too close to the control panel and being damaged when the drawer is pushed in. The floor of the warming drawer has a non-slip mat to prevent plates and dishes sliding when the drawer is opened and closed. The controls consist of the temperature selector knob and the On/Off button. These are only visible when the drawer is open. Controls 8 Using the plate warmer Warming dishes Procedure in brief: ^ Place the dishes in the warming drawer. ^ Select the desired temperature setting. The indicator on the front of the appliance lights up to show that the appliance is on. ^ Turn the appliance off (k), before removing warmed dishes. [. . . ] ^ Plug the plate warmer into the outlet. ^ Push the appliance into the cabinetry and align it. ^ Open the plate warmer drawer and use two screws to secure the plate warmer to the side walls of the cabinetry. 16 Installing the plate warmer Adhering the insulation strips ^ Remove the protective foil from the adhesive strips. Aligning the front of the plate warmer After installing the combination appliance, it may be necessary under certain circumstances to ­ align the front of the plate warmer. ­ align the gap between the plate warmer and the combination appliance. [. . . ]