User manual MIELE G 2570

[. . . ] Operating instructions for dishwashers To avoid the risk of accidents or damage to the appliance it is essential to read these instructions as well as the installation plan before it is installed and used for the first time. G M. -Nr. 06 702 730 Contents Description of the appliance . 12 Before using the appliance for the first time you require: . 13 To call up the water hardness level in the display . [. . . ] If the door is closed again, the programme will continue from the point it was at before the door was opened. Changing a programme Important: If the detergent dispenser flap has already opened, do not change the programme. If a programme has already started and you wish to change it, proceed as follows: ^ Open the door. ^ Select the programme required with the programme selector button. The programme starts. , Water in the dishwasher may be hot. Only open the door if absolutely necessary and exercise extreme caution when doing so. Before closing the door again, leave it ajar for approx. This will enable the temperature in the wash cabinet to settle. Then close the door firmly making sure that it clicks into place. 37 Operation Additional functions Tab function You can programme your dishwasher to ensure excellent results when using tablet detergents by simply selecting the "2 in 1" and "3 in 1" function using the Tab button. The programme sequence will be adjusted to the type of detergent selected. Depending on the programme, the duration can be considerably longer. "2 in 1": When the "2 in 1" function is selected, the programme sequence is adjusted for "2 in 1" tabs (detergent containing rinse aid). The dispensing of rinse aid and the rinse aid refill indicator light are deactivated. "3 in 1": When the "3 in 1" function is selected, the programme sequence is adjusted for "3 in 1" tabs (detergent containing rinse aid and salt substitutes). The dispensing of rinse aid and the rinse aid refill indicator light are deactivated. Salt consumption in the water softener is reduced to between 1/4 and 1/3 of the normal amount. Do not select the "3 in 1" function if: ­ using "2 in 1" tabs (detergent with rinse aid) ­ if your water hardness level is above 3. 8 mmol or 21 °d. Follow the detergent manufacturer's instructions. The washing and drying performance of these types of detergent can vary enormously. ^ Open the door. ^ Switch the dishwasher on with the On button g. ^ Press the Tab button until the detergent type of your choice ("2 in 1" or "3 in 1") lights up. If neither of the indicators lights up, the dishwasher is set for normal detergent. The function selected is active on all programmes until the setting is changed. [. . . ] ­ The water pressure (flow pressure at the take-off point) must be between 30 and 1000 kPa (0. 3 and 10 bar). If the water pressure is too high, a pressure reducing valve must be fitted. !The inlet hose must not be shortened or damaged in any way as it contains electrical components (see illustration). 64 Plumbing Drainage ­ The appliance drainage system is fitted with a non-return valve, which prevents dirty water from flowing back into the dishwasher via the drain hose. ­ The dishwasher is supplied with approx. 1. 5 m of flexible drain hose with an internal diameter of 22 mm. [. . . ]