User manual MIELE G 600 SC

[. . . ] Com manuals search engine G600 & G800 Electronic Dishwashers Technical Information G600 &G800 Electronic Dishwashers – List of Figures (continued) 5-11: Exterior view of the Inner Door Panel. 85 5-30: Placing the Circulation Pump Tool into . 86 5-31: Engaging the tool prongs into the Circulation Pumps Impellers. 90 5-36: Releasing the Overflow Level Switch from the Connecting Strip . [. . . ] The same water will continue to be used to reduce water consumption. If the Turbidity Sensor and electronic determine the water to be “dirty”. Then the program will continue with a drain at the end of the PreWash, and a fill during the Main Wash. Com manuals search engine G600 & G800 Electronic Dishwashers Technical Information The sensor is located within the plumbing connection between the Circulation Pump and Top Spray Arm. In order to compensate for residues on the sensor and ageing of the optical system, the Turbidity Sensor is re-calibrated automatically every time the dishwasher runs a program (the steps on the Timing Chart are marked with a “T “). To prevent residues drying on the sensor surface, the sensor remains in water after the drainage cycle. The activation of components requiring 120VAC power is handled by Thyristors and Relays within the Electronic. The individual components of the Electronic are not replaceable. Should the Electronic require replacement; the Electronic is replaced as one assembled component. 1 Programming After Replacing the Electronic In addition to Intake Duration and Water Softener Settings certain dishwasher Electronics need to be programmed for the width of the dishwasher (45 cm or 60 cm). For further information refer to the model specific programming and service mode(s) information. 2 Electronic Modes The electronic modes are divided into 3 levels: The Programming Mode Service Mode 1 Service Mode 2 The Programming Mode is intended for user access. Service Mode 1 and Service Mode 2 are designed to be accessed only by qualified service personnel. Note - While in Service or Programming Modes… If the dishwasher is switched off; or the door is opened the dishwas her automatically exits the current mode and returns to the operational mode. Adjust the Locking Plate in the direction of the arrow as required 3. Press the appropriate Sealing Compound, into the corners of the Door Seal Groove. Fit the new Seal in accordance with the figure 2; first at the ends and corners of the groove. Press the mid points of the Seal on the edges (Item 3). Work towards the corners and ends, press the Seal into its groove. 3 Side Panel - Removal Figure 5-3: Side Panels and Cabinet Refer to figure 5-3 With the appliance removed from it’s installation location 2. Remove the raised head screws (Items 1 and 3). Service Tip When reinstalling the Side Covers; fit the bottom lip of the panel into the edge of the Drip Tray. [. . . ] - Remove the Door Seal and fit it correctly (5. Excess foaming Too much (or improper type) of detergent and / or rinse aid is being used - Use the correct type and amount of detergent - Reduce the setting on the Rinse Aid Dispenser - If rinse aid spills while filling the Dispenser, wipe it away Detergent added to Rinse Aid Dispenser - Remove the Dispenser (5. 8) and thoroughly flush the dispenser Note If the Dispenser cannot be flushed completely; replace the Dispenser Assembly (5. 8) Detergent not released Basket incorrectly loaded - Load the Basket in accordance with the operating instructions. [. . . ]