User manual MIELE G 863SCVI FULLSIZE DISHWASHER INSTALLATION MANUAL

[. . . ] Installation instructions Integrated dishwasher To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 620 662 Contents IMPORTANT SAFETY INSTRUCTIONS . 3 INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ . 8 Opening the door without a panel in place . [. . . ] 16. 5 lbs (7. 5 kg) Panel Height = HTC - TKH HTC = Height to the underside of countertop TKH = Toe Kick Height 17 Installation The door panel is attached to the dishwasher using the mounting bracket that comes secured to the front of the unit. To remove the bracket: ^ Open the door 2 - 4" (5 - 10 cm). ^ Loosen the bracket retaining screw (black arrow) located on each side of the machine door. ^ Pull the bracket up until the upper section of the bracket disengages from the locator pins, then remove the bracket. 18 Installation Install the bracket on the rear of the custom door panel ^ Make sure the dishwasher is level. ^ Measure the distance X between the round hole in the machine outer door panel (shown in inset) and the lower edge of the adjoining cabinet door. ^ Using a pencil, lightly draw a vertical centerline on the panel (See illustration on the next page). ^ Draw a horizontal line X inches up from the bottom edge of the panel. For two piece panels: Two piece panels should be made so that any joining hardware is flush with the back of the panel . Failure to do this may impede proper operation of the dishwasher. In certain instances, you may be able to use the mounting bracket supplied with the machine to secure both pieces to the dishwasher. Consult your cabinet supplier / maker for the best method of joining the panels. ^ Place the door panel on a flat surface, good side face down, being careful not to scratch the surface. Make certain that the bottom of the panel is towards you. When mounting the two pieces, make sure that the desired finished panel height is maintained. 19 Installation ^ Place the bracket on the door panel so the notches, a, cross the previously drawn centerline, and the bottom of the bracket lines up with the horizontal X line. ^ Mark and drill pilot holes for the screws using a 3/32" (2. 5 mm) drill bit. ^ Attach the bracket to the back of the panel, using the 14 screws provided. The top four pair of holes, only need to be secured once per pair. ^ Double check the location of the bracket before mounting the panel to the dishwasher. The door handle must be installed on the panel before it is attached to the machine. It should be located in the center of the panel at a height that will match the surrounding drawer handles. Any screws used to attach the door handle must be countersunk so that the rear of the front panel remains flat. 20 Installation Attach the front panel to the dishwasher ^ Open the door 2 - 4" (5 - 10 cm). The "T" shaped hanger behind the door handle should fit easily into its respective hole. ^ Place the lower mounting clips into the slots of the dishwasher door as shown in the illustration. ^ Seat the U shaped slots of the upper bracket onto their respective locator pins. ^ Press the panel against the door and slide down so that all the brackets catch. 21 Installation 7. Adjust and secure the front panel Once installed, the panel can be raised or lowered up to 1/16" (2 mm) to match the cabinet lines. [. . . ] Test the unit Once the dishwasher is level and secured it should be tested. ^ Remove all packing and literature from inside the unit. The yellow Child Safety Lock key hung on the upper basket must be removed before operating the dishwasher. If not removed, the key could become lodged in the circulation pump. [. . . ]