User manual MIELE G 879 SCVI

[. . . ] Operating and installation instructions Dishwasher G 879 SCVi In order to protect yourself and avoid damage to your machine, it is absolutely necessary to read the operating and installation instructions prior to installation and operation. ] M. -Nr. 05 038 402 Contents Contents Guide to the appliance. 13 To check the programmed water hardness: . 14 Setting the water hardness selector inside the wash cabinet. [. . . ] Do not place dishes, bowls or other hollow containers in the bottom basket. Adjusting the upper basket to its lowest position will allow it to accommodate larger plates. Because smaller amounts of dishware are being washed, the amount of detergent used can be reduced accordingly. Using "Top Solo" will also save water and energy. For example, using "Top Solo" with the UNIVERSAL 55 °C/130 °F programme uses 12 litres (2. 6 Imp. gallons) of water instead of the usual 19 litres (4. 2 Imp. "Top Solo" can be selected with all wash programmes. The indicator lamp next to the touch pad will illuminate. Close the door to start the programme. 33 Additional features Heated drying A heating element is used to help dry the dishes in all wash programmes. The "Heated drying" feature can be turned off if desired. The dishes will then be dried using the residual heat inside of the machine. For faster drying, the dishwasher door can be opened 2" - 3" at the end of the programme to allow the moist air to escape. To turn off "Heated drying", proceed as follows: Open the door. Press and hold buttons b and d while simultaneously turning on the dishwasher. The "ON" indicator lamp will light and the "8 k" and c lamps will flash. If any other indicator lamps flash, turn off the dishwasher and start again. The "8 k" indicator lamp will flash as long as you are in the programming mode. If the b lamp lights up, "Heated drying" is already turned off. If the lamp is not lit, proceed as follows: Turning on "Heated drying". In order to turn "Heated drying" back on, follow the same procedure, making sure the b indicator lamp is off before storing the change using the 2 button. "Heated drying" is now turned off. Its indicator lamp will light up and indicator lamps b through f will go out (if previously lit). The 2 and "8 k" indicators will flash. [. . . ] If the water pressure is too low the machine may not take in enough water in the allowed time and the "Water Intake" indicator lamp will flash (see "Problem solving guide"). If the water pressure is too high, a pressure reducer must be installed. For the Miele "Waterproof" leak protection system to function properly the inlet hose must be connected to the shut-off valve in the correct manner (As shown here). Hot water supply specifications: Recommended temperature: 49°C (120°F) Maximum temperature: 60°C (140°F) Water pressure: 0. 3 - 10 bar (4. 5 - 145 psi) An air gap is built into the water inlet system and will prevent potable water mixing with waste water should a vacuum occur in water pipes. 68 Plumbing The protective outer cover must not be damaged in any way. Lay the hose in such a way that it does not rise above the bottom of the "Waterproof" unit casing. Connect the inlet hose wth the "Waterproof" system vertically, use angle connector if necessary. [. . . ]