User manual MIELE G 881 DISHWASHER OPERATING MANUAL

[. . . ] Operating instructions for G 681 / G 881 dishwasher To prevent accidents and machine damage, read the Operating Instructions before installing or using the machine. ö] M. -Nr. 05 255 501 Contents Contents Guide to the appliance . 6 INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ . 13 Programming and setting the water hardness level . [. . . ] Available programs and their applications are listed in the Program Chart. The "Top Solo" feature can be used with each of these programs. For further information on "Top Solo", see "Additional features". "Energy Saver" Program Approximately 0. 20 kWh of electricity is used during this cycle. ^ Use this program for light to normally soiled dishes. The water is not heated in this program. The dishwasher must be connected to hot water of at least 45 °C/115 °F for this program to clean well. The drying result may not match that of a program with a full drying cycle. The higher the temperature of the incoming water, the better the washing and drying results will be. ^ Opening the door of the dishwasher 2-3 inches (5-6 mm) at the end of the program will speed drying. 31 Operating the dishwasher Turning on the dishwasher ^ Make sure spray arms are not blocked. ^ Press the "On/Off" button (14). The light ring around the program selector (18) and the decimal point in the time display (15) will light. Note: "Delay Start" or "Top Solo" must be selected before the program is started (see "Additional features"). ^ Press the "Start" button (21). The "Start" indicator light (21) goes out and the "Rinse" indicator (16) lights. If a program is ended prematurely, important program steps (e. reactivating the water softener) may be omitted. Starting a program ^ When selecting a program, refer to the program chart in the operating instructions. ^ Turn the program selector (18) clockwise or counter clockwise to the desired program. The running time of the program selected shows in the time display (15) in hours and minutes. The "Time Left" indicator next to the time display (15) and the "Start" indicator (21) light. 32 Operating the dishwasher Program sequence indicator lights (16) The "Rinse" indicator light comes on in the Rinse & Hold, Main wash, Interim rinse and Final rinse stages of a program. The "Drying" indicator lights during the drying stage of the program. Each time a program is run the electronic unit takes into account the new conditions and calculates the program time required. This new figure is then displayed. Light ring (18) The light ring illuminates when the dishwasher is turned on and goes out at the end of a program. It will come on again if the program selector is turned to "Stop" or the door is opened and then closed. [. . . ] This allows a technician to update the programming of the dishwasher to make use of new technological developments. For example, if a detergent that gives good wash results using only cold water were to become available, the wash programs can be modified to take advantage of this. 55 Special accessories Special accessories To make the most of your dishwasher If you would like. . . milk or baby bottles . . . to wash a large number of glasses . . . to wash long-stemmed glassware then you need. . . a bottle holder . . . a glassware insert for the bottom basket . . . [. . . ]