User manual MIELE G 890

[. . . ] Operating instructions for the G 890 dishwasher To prevent accidents and reduce the risk of damaging the machine, read the Operating Manual before installing or using the machine. ö M. -Nr. 04 329 631 2 Contents Contents Guide to the appliance. 16 Setting the water softener for a hardness level of 1 - 35 gr/gal . 16 Setting the water softener for a hardness level of 36 - 70 gr/gal . [. . . ] The program indicator lamp (17) and the lamps for any additional features selected (e. g. Top Solo) will remain lit until the door is opened. The dishwasher can be unloaded as soon as the "0" appears in the display (see Unloading the Dishwasher). If the dishes are not needed immediately however, leaving the door closed while "0" is displayed will allow the fan to run for a few more minutes and ensure thorough drying. Turning off the dishwasher At the end of a program: Press the "ON/OFF" button (16). If the dishwasher is not to be used for an extended period (e. g. while on vacation), it is recommended that the water supply valve be shut off. Your Miele dishwasher is designed to shut off the water flow and drain the machine in the rare event of a valve failure. In order for this function to be active, the door must be shut and the machine must be "ON". 33 Operating the dishwasher Interrupting a program A program can be interrupted by opening the door. If the door is then closed, the program will continue from the point it was at before the door was opened. The water in the dishwasher may be hot, and steam may be present!Only open the door if absolutely necessary and exercise extreme caution when doing so. The danger of burns and scalding exists. Once the door has been opened, allow 20-30 seconds for the internal temperature to equalize before closing it again, and make sure it clicks into place. Changing a program If the "START/Stop" button has not yet been pushed: Select the new program. "Delay start" or "Top Solo") desired. Press the "START/Stop" button (22). The indicator lamp next to the "START/ Stop" button will go out and the program will start. If the program is already running: Press the "START/Stop" button (22) for at least one second. The indicator lamp next to the Program Selection Button and the decimal point in the Time display will light. "Delay start" or "Top solo" desired. Press the "START/Stop" button (22). The indicator lamp next to the "START/ Stop" button will go out and the new program will begin. 34 Additional features Additional features Delay start (20) The start time of a program can be delayed up to 24 hours in order to take advantage of off peak utility rates that exist in many areas. A delay time of between 30 minutes and 9 hours 30 minutes can be selected in 30 minute intervals. [. . . ] Electrical wiring and components should not come into contact with any plumbing fixtures or hoses. 67 Plumbing Drain system specifications: The machine comes equipped with: ­ A 5 ft. long (1. 5 m) flexible drain hose with an internal diameter of 7/8" (22 mm). ­ A built-in swivel connector which allows the drain hose to be routed in any direction. ­ A built in non-return valve on the discharge side to prevent waste water from flowing back into the dishwasher. [. . . ]