User manual MIELE G 891

[. . . ] Operating instructions for G 891 dishwasher To prevent accidents and machine damage, read the Operating Instructions before installing or using the machine. ö] M. -Nr. 05 255 651 Contents Contents Contents . 6 INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ . 13 Programming and setting the water hardness level . [. . . ] Note: "Delay start" or "Top Solo" must be selected before the program is started (see "Additional features"). ^ Press the "Start/Stop" button (22). The indicator light next to the "Start/Stop" button goes out. Do not end a program prematurely or important program steps could be omitted (e. reactivating the water softener). Starting a program ^ When selecting a program, refer to the Program Chart of the operating instructions. All indicator lights next to the program buttons, except the selected program, go out. The indicator light next to the "Start/ Stop" button comes on. Program sequence indicator lights (15) After a program has been started the current step of the program is indicated by the program sequence indicator lights (15). 31 Operating the dishwasher Time display (19) The running time of a program is shown in hours and minutes in the time display before a program is started. During a program the time left until the end of the program is displayed. The "Time left" indicator light next to the time display lights. The time displayed may vary with the same program. This is due to the water inlet temperature at each intake and the load size being washed. When the dishwasher is first turned on the display shows an average time for a cold water intake. Times shown in the program chart refer to normal loads and average temperatures. Each time a program is run the electronic unit takes into account the new conditions and calculates the time required. This figure is shown in the time display. At the end of a program A program has finished when the "End" indicator light is on in the program sequence display (15) and a "0" shows in the time display (19). The indicators illuminate for the selected program just finished and any additional functions which were chosen. These will go out when the dishwasher door is opened. The dishwasher can now be opened and unloaded (see "Unloading the dishwasher"). If the dishwasher is left closed, the fan will continue for a few minutes to remove any remaining moisture. This process is not part of the program. Only open the door immediately after a program has ended if dishes or cutlery are urgently needed. ^ Always turn the dishwasher off if another program is not started immediately. 32 Operating the dishwasher Turning off the dishwasher At the end of a program: ^ Press the "On/Off" button (16). [. . . ] These can be found on the data plate on the upper inside edge of the dishwasher door. Program update function - PC The "PC" indicator has the function of Program Correction (PC). This allows a technician to update the programming of the dishwasher to make use of new technological developments. For example, if a detergent that gives good wash results using only cold water were to become available, the wash programs can be modified to take advantage of this. 54 Special accessories Special accessories To make the most of your dishwasher If you would like. . . milk or baby bottles . . . to wash a large number of glasses then you need. . . [. . . ]