User manual MIELE H 4431 PYRO

[. . . ] Operating instructions Pyrolytic ovens H 4331, H 4431 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 513 800 2 Contents Description of the appliance . 17 Set the time of day for the first time . 17 Cleaning and heating up for the first time . [. . . ] At the end of a set time five short beeps sound and are repeated every five minutes. This reminder continues for up to an hour. A continual beep sounds after a set time has elapsed. The appliance is not secured against unintentional switching on and programmes can be altered. The appliance is secured against unintentional switching on and programmes cannot be altered. See the relevant chapters in this booklet for instructions on how to activate these safety features. SI P 2 Buzzer S0 SI S2 S 3* P3 Buzzer duration S 0* SI P 4 System lock / Safety lock S 0* SI 42 Altering oven settings v Oven setting P 5 Catalyser (depending on model) Settings available (* factory default) S0 The catalyser is switched off, cooking odours are not dissipated. The catalyser is switched on for all cooking functions, cooking odours are dissipated. The catalyser engaged for all functions except for Gentle bake. The U symbol will appear in the display during Fan plus Y, Auto roast E and Conventional CB. The auto heat-up function is switched off. To bring to the boil you first have to select the maximum hob zone setting and once the food is boiling you must manually turn the power setting down. The auto heat-up function is switched on. When a hob zone setting is selected, the hob will start heating up on maximum power and then automatically reduce the power for continued cooking. SI S 2* P 6 Rapid heat-up S0 S I* P7 Auto heat-up (applies to cookers with hobs only) S0 S I* 43 Altering oven settings v Oven setting P 8 Fan run-on Settings available (* factory default) S 0 * The cooling fan run-on time is temperature controlled and will not switch off until the oven interior temperature is below 70 °C. SI The cooling fan run-on time is time controlled to switch off after 25 min. Do not leave food in the oven to keep it warm if you have set the cooling fan to timed operation. Moisture levels in the oven could increase, leading to condensation forming on the control panel and surrounding kitchen furniture and drops of moisture collecting under the worktop. Condensate can ­ damage the housing unit / worktop. P 9 Light S0 S I* P I0 Factory default S0 S I* P II Demo mode (for dealer showroom use only) The light switches itself off automatically after approx. Standard factory default settings have been altered. Factory default settings reinstated. ---- * Demo mode not active. Four horizontal bars appear in the display. MES_ The oven is set to the showroom demo programme. [. . . ] Make sure that these figures comply with the main voltage. Connection should be made via a suitable isolator which complies with national and local regulations. The appliance is supplied with a 3-core cable for connection to a 230-240 volt 50 Hz supply. The fuse rating is 20 amps for the "B"-model. [. . . ]