User manual MIELE INTEGRATED SLIMLINE DISHWASHER-M

[. . . ] Installation instructions Integrated slimline dishwasher To prevent accidents and machine damage, read these instructions before installation or use. UV M. -Nr. 05 620 691 Contents IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS IMPORTANTES SUR LA SÉCURITÉ Caring for the environment Disposal of the packing material . 7 Opening the door Opening the door without a panel in place . 8 Without the mounting bracket in place: . [. . . ] The drain hose connection at the rear of the dishwasher can be turned to allow the hose to be angled to the right or left. ^ Pull the bracket up until the upper section of the bracket disengages from the locator pins, then remove the bracket. 16 Installation Install the bracket on the rear of the custom door panel ^ Push the dishwasher into its opening and adjust the height. ^ Measure the distance X between the round hole in the machine outer door panel (shown in inset) and the lower edge of the adjoining cabinet door. ^ Using a pencil, lightly draw a vertical centerline on the panel (See the illustration on the next page). ^ Draw a horizontal line X inches up from the bottom edge of the panel. For two piece panels: Two piece panels should be made so that any joining hardware is flush with the back of the panel. Failure to do this may impede proper operation of the dishwasher. In certain instances, you may be able to use the mounting bracket supplied with the machine to secure both pieces to the dishwasher. Consult your cabinet supplier / maker for the best method of joining the panels. When mounting the two pieces, make sure that the desired finished panel height is maintained. ^ Place the door panel on a flat surface, good side face down, being careful not to scratch the surface. Make certain that the bottom of the panel is towards you. 17 Installation ^ Place the bracket on the door panel so the notches, a, cross the drawn centerline, and the bottom of the bracket lines up with the horizontal X line. ^ Mark and drill pilot holes for the screws using a 3/32" (2. 5 mm) drill bit. ^ Attach the bracket to the back of the panel, using the 14 screws provided. The top four pair of holes, only need to be secured once per pair. ^ Double check the location of the bracket before mounting the panel to the dishwasher. The door handle must be installed on the panel before it is attached to the machine. It should be located in the center of the panel at a height that will match the surrounding drawer handles. Any screws used to attach the door handle must be countersunk so that the rear of the front panel remains flat. 18 Installation Attach the front panel to the dishwasher ^ Open the door 2 - 4" (5 - 10 cm). The "T" shaped hanger behind the door handle should fit easily into its respective hole. ^ Place the lower mounting clips into the slots of the dishwasher door as shown in the illustration. ^ Seat the U shaped slots of the upper bracket onto their respective locator pins. ^ Press the panel against the door and slide down so that all the brackets catch. 19 Installation 6. Adjust and secure the front panel Once installed, the panel can be raised or lowered up to 1/16" (2 mm) to match the cabinet lines. ^ Once this side of the panel lines up with the cabinets, secure it by tightening the upper screw on the edge of the dishwasher door. ^ Repeat the process with the other side of the panel. [. . . ] Test the unit Once the dishwasher is level and secured it should be tested. ^ Remove all packing and literature from inside the unit. The yellow Child Safety Lock key hung on the upper basket must be removed before operating the dishwasher. If not removed, the key could become lodged in the circulation pump. [. . . ]