User manual MIELE K 8952 SD ED

[. . . ] Operating and installation instructions Refrigerator with Dynamic cooling K 8952 SD ed-1 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. GW M. -Nr. 06 777 840 Contents Description of the appliance . 13 Switching off for longer periods of time . 17 Food which should not be stored in a refrigerator. [. . . ] Protein rich foods Please note that foods rich in protein deteriorate faster than others. Shell fish, for example, deteriorates faster than fish, and fish deteriorates faster than meat. Meat Meat should be stored loosely covered in suitable containers or packaging. Allowing the surface of the meat to dry slightly helps to prevent the growth of bacteria. To prevent the risk of bacterial cross-contamination meat should not be allowed to come into contact with other foods. 18 Adjusting the interior fittings Moving the shelves The shelves can be adjusted according to the height of the food. ^ Raise the shelf at the front, pull it out half way, and then lift it out. ^ With the rear barrier facing upwards, place the shelf at the required position. The rear barrier must face upwards to prevent food from touching the back of the appliance and freezing to it. Adjusting the door shelves ^ Push the door shelf upwards, then remove it by pulling it forwards. ^ Replace the door shelf at the required position. Ensure that it is securely pushed back into position. Moving the bottle divider (depending on model) The bottle divider can be moved to the left or right to ensure that bottles are held securely in position when the door is opened and shut. Split shelf In order to accommodate tall items in the appliance, one of the shelves is divided. The front section can be pushed under the rear section. ^ Pull the front half of the glass shelf forwards slightly and then push it carefully under the rear half. 19 Automatic defrost Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. These are automatically removed and defrosted by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance. Ensure that the condensate channel and drain hole are kept clean and are never blocked so that condensate can flow away without hindrance. 20 Cleaning and care Before cleaning Never use cleaning agents containing abrasive substances such as sand, soda, acids or chemical solvents. "Non-abrasive" cleaning agents are also unsuitable as they can cause matt areas to appear. Stainless steel surfaces can be buffed using a proprietary conditioning agent for stainless steel such as Neoblank (available from the Miele UK Spare Parts Department). Follow the manufacturer's instructions and apply with an even pressure following the direction of the grain. Make sure that water cannot get into the electronic unit or into the lighting. Do not let water get into the drainage channel and drain hole when cleaning. Do not use steam cleaning apparatus to clean the appliance. Steam could reach the electrical components and cause a short circuit. [. . . ] ^ Remove spacer k with a screwdriver and refit it on the opposite side. ^ Remove plug l from the door bearing bush in the door and refit on the opposite side. ^ Turn door support b through 180°, pull hinge pin a out, and then fit both parts into hinge plate f: To do this push hinge pin a the other way round through hinge plate f into door support b. Swing the door support in, push upwards and re-assemble with screw c. 32 Changing the door hinging ^ Align the door with the appliance housing using the long slot in hinge plate f. [. . . ]