User manual MIELE KM 5773 IND

[. . . ] Operating and Installation instructions Ceramic hobs with induction KM 5773 To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. Gi M. -Nr. 06 721 380 Contents Guide to the appliance . 15 Cleaning and heating up for the first time . 24 Switching off and residual heat indicators. [. . . ] These functions are described one by one on the following pages. The Combi mode is described in the section of that name. You can set a time of 1 to 99 minutes using the Timer function. Use the sensor to reduce the time from 99 to 00 and the + sensor to increase the time from 00 to 99. The display can be put back to 00 by touching - and + at the same time. On all functions, 00 will appear in the display for a few seconds at the end of the time, and an audible tone will sound at the same time. To turn the audible tone off before it has finished, touch the m sensor. Setting the minute minder The minute minder can be used with the hob switched on or off. 00 will show in the Timer/Memory display. ^ Touch the - or + sensor until the time you require appears in the display, e. g. 15 minutes. The time then counts down in minutes. The time remaining can be seen in the display and changed at any time by touching - or +. 26 Timer and Memory function Switching a cooking zone off automatically You can set a time at the end of which a given cooking zone will switch off automatically. This automatic switch-off function can be used on all of the cooking zones at the same time. ^ Select a power level for the zone you require, e. g. ^ Touch the m sensor until the indicator lamp for the selected zone flashes (back right). If more than one cooking zone is switched on, the indicator lamps will light up clockwise beginning with the front left zone. ^ Touch the - or + sensor until the time you require appears in the display, e. g. If more than one switch-off time is programmed, the shortest time remaining will show in the display, and the indicator lamp for that particular cooking zone will flash. All the other indicator lamps will light up constantly. If you want to check on the remaining time for another zone, touch the m sensor until the indicator lamp for the zone you require flashes. Timer starting value The timer is set at the factory so that it starts with 01 or 99 when the + or sensor is touched. This setting can be adjusted so that the time you last used appears in the display when you press + or - (see "Programming - P14. "). Example: If P14, S1 is programmed, and the last time the minute minder was used was for 5 minutes, 00 will appear in the display when you switch on the Timer; when you then touch + or -, the display will change to 05. You can still select any time you want, even if you have adjusted the timer default setting. The time then counts down in minutes. [. . . ] This is important to ensure an effective seal all round. ^ Check that the hob works. 48 Installation Sealant Do not use any sealant unless expressly instructed to do so. The sealing strip under the edge of the top part of the hob provides a sufficient seal for the worktop. Do not use sealant between the frame of the top part of the hob and the worktop. [. . . ]