User manual MIELE KM 400

[. . . ] Operating instructions Ceramic hobs KM 400 KM 400-3 KM 412 To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time. GHirZ M. -Nr. 04 930 371 Contents Guide to the appliance . 13 Cleaning and heating up for the first time . 24 2 Guide to the appliance KM 400 b c d g f e h i a Double circle zone (Ø 12 cm / 18. 5 cm; rating 700 W / 1700 W) b Single circle cooking zone (Ø 14. 5 cm; rating 1100 W) c Control knob for cooking zone b d Operating indicator lights for the cooking zones f Control knob for cooking zone a f Residual heat indicators for the cooking zones g Mains connection cable h Plug (Depending on country of destination, the appliance may be supplied with or without a plug. [. . . ] Do not flambé under a cooker hood. The flames could set the cooker hood on fire. 10 Warning and Safety instructions Appliance faults In the event of damage or a defect, switch off the appliance immediately. Disconnect completely from the electricity supply. If the appliance has not yet been fully installed, the electricity cable must be disconnected from the supply point. If connected via a plug and socket, switch off at the socket and withdraw the plug. Do not reconnect the appliance to the mains electricity supply until after it has been repaired. If there is any damage to the ceramic surface the appliance must be disconnected from the mains electricity supply immediately and not used until it has been repaired. Repairs must only be carried out by a suitably qualified and competent person. Repairs and other work by unqualified persons could be very dangerous and could damage the appliance. The manufacturer cannot be held liable for unauthorised work. Never open the housing of the appliance. Please do not therefore dispose of your old appliance with your household waste. Please dispose of it at your local community waste collection / recycling centre and ensure that it presents no danger to children while being stored for disposal. It should be unplugged or disconnected from the mains electricity supply by a competent person. If connected by a plug, the plug must be rendered useless and the cable cut off directly behind the appliance to prevent misuse. 12 Before using for the first time General notes Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service" section of this booklet. Cleaning and heating up for the first time Before using for the first time clean the appliance with a damp cloth and then dry with a soft cloth. Do not use washing up liquid to clean the ceramic surface as it can leave a blue sheen which may be difficult to remove. Metal components have a protective coating which may give off a slight smell when the hob is heated up for the first time. The smell and any vapours will dissipate after a short time and do not indicate a faulty connection or appliance. 13 Use Switching on and off To switch on the single zone of a double circle or extended cooking zone (symbol n on the control knob): Turn the appropriate control knob clockwise a. To switch off: Turn the control knob anti-clockwise b to "0". The control knob can only be turned anti-clockwise as far as the "0" setting. Do not attempt to turn the control knob clockwise past the n symbol. Switching on the outer circle or extended cooking zone Use the outer circle of the double circle cooking zone or the extended cooking zone for larger pans. To switch on: ^ Turn the control knob in a clockwise direction past "12" to the n symbol. [. . . ] Check whether the appliance has been switched on at the mains and that the mains fuse is in order. If the fuse has blown, contact an electrician or the Service department. a cooking zone switches on and off at the highest setting. The overheating protection has activated (see "Overheating protection"). 21 Electrical connection All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with current local and national safety regulations (BS 7671 in the UK). [. . . ]