User manual MIELE KM 5773

[. . . ] Operating and Installation instructions Ceramic Cooktop with induction KM 5773 To prevent accidents and appliance damage, read these instructions before installation or use. V M. -Nr. 06 733 330 Contents Guide to the cooktop . 24 Switching a burner off automatically . 49 3 Guide to the cooktop Cooktop abcde burners Sensors Control panel f Power selector g Booster h Turning on the timer, switching between the functions, selecting a burner j Child Safety Lock k Setting the time / Selecting the memory program l Cooktop ON/OFF m Memory function Indicator: i Lock 4 Guide to the cooktop Burner indicator n Display: 0 = 1 to 12 = # = ß = F = A = P0 etc. [. . . ] The time remaining can be seen in the display and changed at any time by touching - or +. 24 Timer and Memory function Switching a burner off automatically You can set a time at the end of which a given burner will switch off automatically. This automatic switch-off function can be used on all of the burners at the same time. ^ Select a power level for the zone you require, e. g. ^ Touch the m sensor until the indicator lamp for the selected zone flashes (back right). If more than one burner is switched on, the indicator lamps will light up clockwise beginning with the front left zone. ^ Touch the - or + sensor until the time you require appears in the display, e. g. If more than one switch-off time is programmed, the shortest time remaining will show in the display, and the indicator lamp for that particular burner will flash. All the other indicator lamps will light up constantly. If you want to check on the remaining time for another zone, touch the m sensor until the indicator lamp for the zone you require flashes. Timer starting value The timer is set at the factory to start at 00 when the + or - sensor is touched. This setting can be adjusted so that the time you last used appears in the display when you press + or - (see "Programming - P14. "). Example: If P14, S1 is programmed, and the last time thetimer was used was for 5 minutes, 00 will appear in the display when you switch on the Timer; when you then touch + or -, the display will change to 05. You can still select any time you want, even if you have adjusted the timer default setting. The time then counts down in minutes. The time remaining can be seen in the Timer/Memory display and changed at any time by touching - or +. If you want to set another burner to switch off automatically, follow the same steps as described above. 25 Timer and Memory function Memory function All settings, which are set to a burner from turning on until turning off, can be recorded in a memory program. 5 frequently used operations can be recorded, but only one at a time can be recorded and used. Memory programs can be recorded for all burners. Multiple programs can be recorded for one burner. Taken programs are marked with a period after the number. To record a new program when all 5 programs are taken, one program must be deleted. Recording a memory program The memory program is selected first and then the burner is used as usual. The maximum saving time is 99 minutes and a maximum of 10 changes to the power level can be made. ^ Touch the sensor + until the desired program number shows. [. . . ] A respective seal tape ensures a non-slip fit of the cooktop in the cut-out. The gap between frame and cooktop will be reduced over time. Installing the cooktop ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. ^ Insert the cooktop in the middle of the cut-out. When doing so make sure that the cooktop seal sits tightly on the countertop to ensure a correct seal is provided. [. . . ]