User manual MIELE KM 191 ELECTRIC COOKTOP OPERATING MANUAL

[. . . ] Gas appliances should only be installed in a well ventilated area. The countertop must be bonded with heat resistant (212 °F / 100 °C) adhesive to prevent distortion or dissolving. The cooktops should only be installed as shown, while maintaining the required safety distances shown. Do not install the cooktop between two tall cabinets, this is a fire hazard. [. . . ] Both the valve and the regulator must be easily accessible to the consumer after the appliance is installed. This appliance must be disconnected from the gas supply during any pressure testing of the system performed in excess of ½ psi (3. 5 kPa). This appliance must be isolated at test pressures equal to or less than ½ psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. There must be a safety distance of at least 30" (760 mm), b between the appliance and any objects above it. The overhead cabinet depth, c, if unprotected, must not exceed 13" (330 mm). The minimum distance of combustible surfaces located above and to the sides of the cooktop, d, is 18" (457 mm). If the cabinet manufacturer recommends a greater distance, follow that manufacturers recommendation. When installing the cooktop under a venting hood, always observe the minimum distance recommended by the hood manufacturer. Safety distances above the appliance Keep this instruction book in a safe place for future reference and pass it on to an future user. 5 Appliance dimensions KM 320 a Brackets b Built-in depth ^ Rember to maintain the minimum safety distances to combustible surfaces: - 2 3/4" (70 mm) between the cooktop and the back wall and - 12" (305 mm) between the cooktop and a side wall or tall unit to the right or left of the cooktop. (See "Important Safety instructions"). 6 Installation Setting the cooktop into place Securing the support brackets d c ^ Place the brackets, a, as shown. ^ After removing the protective backing, d, stick the supplied seal, c, under the edge of the cooktop. Note to the installer Please leave these instructions with the consumer or the appliance. 9 Gas connection Installation and service must be performed by a qualified installer, service agency or the gas supplier. In Massachusetts a licensed plumber / gas fitter is required. This appliance must be installed with its own shut off valve and the included gas pressure regulator. Both the valve and the regulator must be easily accessible to the consumer to turn on or shut off the gas supply after the appliance is installed. This appliance and its individual shut off valve must be disconnected from the gas supply during any pressure testing of the system performed in excess of 1/2 psi (3. 5 kPa). The appliance must be isolated from the gas supply line, by closing its individual manual shut off valve, at test pressures equal to or less than 1/2 psi (3. 5 kPa). Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. The gas connection must be made in accordance with local codes or, in the absence of local codes, with: the National Fuel Gas Code, ANSI Z 21. 1 / NFPA 54 for the USA or - the current Can / CGA B 149. 1 and . 2 Installation Codes for gas burning appliances for Canada. Make sure that the maximum gas supply pressure, before the gas pressure regulator, is never more than 1 /2 psi for both natural gas or LP gas. The minimum supply pressure to get the required gas input is: 6" w. c. [. . . ] Make sure the regulator is easily accessible for adjustment after the appliance has been installed. For convenience, an AGA or CGA approved flexible stainless steel gas hose (accordion type) may be used between the gas connection and the regulator. This will allow the appliance to be lifted out of the countertop for cleaning or servicing. Make sure that any drawers, cabinet doors, etc. , do not rub on this gas hose. [. . . ]