User manual MIELE KM320LP INSTALLATION MANUAL

[. . . ] (In Massachusetts a licensed plumber / gas fitter) ­ Note to the installer: Please leave this instruction book with the consumer for the local electrical / gas inspector's use. 2 Contents IMPORTANT SAFETY INSTRUCTIONS . 13 3 IMPORTANT SAFETY INSTRUCTIONS Installation The minimum distances given in these Installation instructions are to combustible surfaces, and must be observed to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first, to prevent damage to the cooktop. [. . . ] See "Gas connection - Gas pressure regulator". The included gas regulator/adapter combination must be installed between the cooktop and the gas shut off valve. If clearance for the regulator does not exist directly under the cooktop, it may be moved closer to the shut off valve. ^ Guide the power cord through the cut-out. ^ Set the cooktop in the cut-out and center it. 7 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service. 8 Electrical connection This appliance must be grounded according to local or national codes. All electrical work should be performed by a qualified electrician in accordance with local codes and the: National Electrical Code ANSI / NFPA No. 70 for the USA This appliance is equipped with a three-prong grounding plug to prevent shock hazards. It should be plugged directly into a properly grounded outlet. Do not cut or remove the grounding prong from the plug. If the plug does not fit the outlet, have a proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1). , WARNING Disconnect the appliance from the main power supply before installation or service. To reduce the risk of electric shock, make sure the appliance is properly grounded after installation. Power supply The automatic ignition requires that the cooktop be connected to a 120 VAC, 60 Hz power supply. The supply line should be protected by a 15 A breaker. Actual power consumption (during ignition only) is 25 W. (1. 2 m) long power cord that is ready for connection to the appropriate outlet. Please place the power outlet so that it is accessible after the appliance has been installed in the countertop. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. [. . . ] Do not use any regulator/adapter unless it has been supplied by Miele. If there is any doubt concerning installation contact the Miele Technical Service Department: U 1-800-999-1360 techserv@mieleusa. com V 1-800-565-6435 service@miele. ca After connecting the appliance check all fittings for gas leaks e. g. When installed properly, the flame will be steady and quiet. It will also have a sharp, blue inner core that will vary in length proportional to the burner size. [. . . ]