User manual MIELE KM342LP INSTALLATION MANUAL

[. . . ] (In Massachusetts a licensed plumber / gas fitter) ­ Note to the installer: Please leave this instruction book with the consumer for the local electrical / gas inspector's use. 2 Contents IMPORTANT SAFETY INSTRUCTIONS . 16 3 IMPORTANT SAFETY INSTRUCTIONS Installation The minimum distances given in these Installation instructions are to combustible surfaces, and must be observed to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first to prevent damage to the cooktop. [. . . ] (See "Important Safety instructions"). 7 Installation Setting the cooktop into place Securing the cooktop ^ Secure the cooktop with the included fixing bracket. Countertop 13/16" (20 mm) d c ^ After removing the protective backing, d, stick the supplied seal, c, under the edge of the cooktop. ^ Screw the gas regulator onto the nipple underneath the cooktop. (See "Gas Connection - Gas pressure regulator". ) ^ Feed the power cord through the cut-out to the power outlet. ^ Set the cooktop in the cut-out and center it. Install the appliance so that the power cord and gas piping does not come in contact with any portion of the cooktop which may become hot during use. Countertop 1 9/16" (40 mm) 8 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal. If the cooktop is sealed into position, the countertop or appliance may be damaged if the cooktop needs to be removed for maintenance or service. 9 Electrical connection This appliance must be electrically grounded according to local or national codes. All electrical work should be performed by a qualified electrician in accordance with local codes and the: National Electrical Code ANSI / NFPA No. 70 for the USA To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy, of an effective grounding system. Note to the installer: Please leave these instructions with the consumer or the appliance. This appliance is equipped with a three-prong grounding plug to prevent shock hazards. It should be plugged directly into a properly grounded outlet. Do not cut or remove the grounding prong from the plug. If the plug does not fit the outlet, have a proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1). [. . . ] If there is any doubt concerning installation contact the Miele Technical Service Department at: U 1-800-999-1360 techserv@mieleusa. com V 1-800-565-6435 service@miele. ca a Cooktop b ½" NPT c Regulator As shown in the above diagram, the included regulator must be used when connecting the Miele cooktop to your gas supply. This item has been customized by Miele to meet all applicable safety requirements. Make sure the regulator is easily accessible for adjustment after the appliance has been installed. After connecting the appliance check all fittings for gas leaks e. g. [. . . ]