User manual MIELE KM391-GAS COOKTOP

[. . . ] Operating and Installation Instructions Gas Cooktop KM 391 ® To prevent accidents and machine damage, read these instructions before installation or use. ® UV M. -Nr. 06 073 600 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] ^ Clean the grates and knobs with a sponge and a mild solution of warm water and liquid dish soap. Dry grates and knobs thoroughly after cleaning. Ceramic surface The ceramic surface should be cleaned regularly, preferably after each use. ^ Before cleaning allow the cooktop to cool down. Stubborn spills are best removed with a shielded scraper blade. ^ Sugar or syrup spills must be cleaned before the cooktop cools completely or the glass will dimple. ^ Apply a cleaner for ceramic surfaces using a soft cloth or paper towel. This will prevent any water marks caused by water boiling over. ^ Wipe the ceramic surface with a damp cloth and then dry it with a clean soft cloth. 15 Cleaning and care Burner The burner can be dismantled and cleaned when completely cool. Dismantling and cleaning ^ Remove the burner parts and wash them in a solution of hot water and liquid dish soap. Make sure that the flame holes are clean and completely dry. The shiny surfaces of the burner caps will dull with time and usage. This is normal and will not affect the operation of the cooktop. ^ Wipe the burner base clean with a damp cloth and then dry. ^ Gently wipe the ignitor and ignition safety control with a damp cloth, and then dry with a soft cloth. The ignitor must be thoroughly dry, or it will not spark. Make sure that all the locating tabs and notches align exactly. ^ Place the burner head, b, onto the burner base, a, so that the ignition safety control and ignitor extend through their respective holes. Reassembling Auxiliary, Normal and Fast burner 16 Cleaning and care Reassembling the wok burner Be careful not to mix up the parts. Make sure that all the locating tabs and notches align exactly. ^ Place the burner head, o, on to the burner base, p, so that the ignitor, q, and the ignition safety control, r, extend through their respective holes in the burner head. The burner head must click into place correctly. ^ Replace the burner cap, m. 17 Frequently asked questions . . . [. . . ] ^ Install the new orifice and reassemble the above parts in the reverse order. ^ Take off the burner cap, a, burner ring, b, and burner head, c. ^ Loosen screws, d, and remove the cover plate. ^ Using an M7 socket spanner unscrew the orifices, e, (larger diameter) and, f, (smaller diameter). [. . . ]