User manual MIELE KM 391LP GAS COOKTOP OPERATING AND INSTALLATION MANUAL

[. . . ] Operating Instructions Gas Cooktop KM 391 ® ® To prevent accidents and machine damage, read the Operating Manual before installation or use. UV M. -Nr. 06 073 600 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. [. . . ] Do not use any sharp pointed objects which could damage the seal between the ceramic surface and the surrounding frame or between the frame and the countertop. Never use scouring agents or pads, abrasive cleaning agents or strong cleaners such as oven sprays, stain or rust removers, these could damage the surface of the appliance. Clean the surface of the cooktop with a cleaner for ceramic surfaces. Follow the manufacturer's instructions on the packaging. After cleaning, the ceramic surface must be thoroughly dried with a soft cloth to prevent a build up of limescale deposits. ^ Let the appliance cool to a safe temperature before removing the grates. ^ Clean the grates and knobs with a sponge and a mild solution of warm water and liquid dish soap. ^ Dry grates and knobs thoroughly after cleaning. Ceramic surface The ceramic surface should be cleaned regularly, preferably after each use. ^ Before cleaning allow the cooktop to cool. Stubborn spills are best removed with a shielded scraper blade. ^ Sugar or syrup spills must be cleaned before the cooktop cools completely or the glass will dimple. ^ Apply a cleaner for ceramic surfaces using a soft cloth or paper towel. This will prevent any water marks caused by water boiling over. ^ Wipe the ceramic surface with a damp cloth and then dry it with a clean soft cloth. 16 Cleaning and care Burner The burner can be dismantled and cleaned when completely cool. Dismantling and cleaning ^ Remove the burner parts and wash them in a solution of warm water and liquid dish soap. Make sure that the flame holes are clean and completely dry. The shiny surfaces of the burner caps will dull with time and usage. This is normal and will not affect the operation of the cooktop. ^ Wipe the burner base clean with a damp cloth and then dry. ^ Gently wipe the ignitor and Ignition Safety Control with a damp cloth, and then dry with a soft cloth. The ignitor must be thoroughly dry or it will not spark. Make sure that all the locating tabs and notches align exactly. [. . . ] Failure to correctly install these items could lead to a gas leak and subsequent explosion. The gas connection must be made in accordance with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z 21. 1 / NFPA 54 for the USA or - the current Can / CGA B 149. 1 and . 2 Installation Codes for gas burning appliances for Canada. Make sure that the maximum gas supply pressure before the gas pressure regulator is never more than ½ psi for both natural gas or LP gas. The minimum required gas pressure to get the required gas input is 4" w. c. [. . . ]