User manual MIELE KM404

[. . . ] (In Massachusetts a licensed plumber/gasfitter) ­ Note to the installer: Please leave this instruction book with the consumer for the local electrical/gas inspector's use. 2 Contents IMPORTANT SAFETY INSTRUCTIONS . 9 Laying out the support bars and brackets . 15 Nominal ratings for all types of gas . 24 3 IMPORTANT SAFETY INSTRUCTIONS Installation The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. [. . . ] Do not allow the bars to "float", they must be securely fastened. Fill the gap, c, between the bars and the countertop using the supplied silicon sealant. The screws are not necessary for granite countertops. 10 Installation Setting the cooktop into place Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion. ^ Screw the gas regulator/adapter combination onto the nipple at the rear of the cooktop. ^ Guide the power cord through the cut out and set the cooktop into place. ^ Secure the cooktop from below by placing the two supplied screws through the center elongated holes of the support brackets and screwing them into the bottom of the cooktop. 11 Installation Important The cooktop must not be permanently sealed into the countertop when installed. If the cooktop is sealed into position, the countertop or appliance may be damaged if the cooktop needs to be removed for maintenance or service. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. 12 Electrical connection This appliance must be electrically grounded according to local or national codes. All electrical work should be performed by a qualified electrician in accordance with local codes and with the: National Electrical Code ANSI / NFPA No. 70 for the USA This appliance is equipped with a three-prong grounding plug to prevent shock hazards. It should be plugged directly into a properly grounded outlet. Do not cut or remove the grounding prong from the plug. If the plug does not fit the outlet, have the proper outlet installed by a licensed electrician. or - Canadian Electrical Code Part I for Canada (CSA Standard C 22. 1) , WARNING - Disconnect the appliance from the main power supply before installation or service. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. Power supply The automatic ignition requires that the cooktop be connected to a 120 VAC, 60 Hz power supply. The supply line should be protected by a 15 A breaker. Actual power consumption (during ignition only) is 25 W. This appliance is equipped with a 4. 5 ft. (1. 4 m) long power cord that is ready for connection to the appropriate outlet. Please place the power outlet so that it is accessible after the appliance has been installed in the countertop. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. [. . . ] ^ Remove the orifice, d, and replace it with the new orifice. ^ Rotate the air sleeve, e, until there is a 3/32" (2 mm) gap between the sleeve and the air vent, f, as shown. ^ Reassemble the burners and test the unit for leaks. It can be operated without the upper cover in place by igniting the flames with a match. d Small burner orifice e Air sleeve f Air vent 23 Converting KM 406 Check the intake air After conversion ^ After converting the cooktop to an alternative type of gas, affix the label supplied with the jet kit on to the data plate over the type of gas stated. [. . . ]