User manual MIELE KM452 INSTALLATION MANUAL

[. . . ] 9 3 IMPORTANT SAFETY INSTRUCTIONS Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector's use. Installation The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. [. . . ] The cooktop must not be installed over a dishwasher, washer, dryer, refrigerator or freezer. The high temperatures radiating downwards from this type of cooktop could damage these appliances. Make sure that the power cord to the cooktop does not come in contact with any mechanical parts once the cooktop has been installed. Safety distances above the appliance Maintain a safety distance of at least 30" (760 mm), b, between the appliance and any flammable objects above, e. g. cabinetry, venting hood or utensil rail. The minimum distance of combustible surfaces located above and to the side of the cooktop, c, is 18" (457 mm). If the manufacturer of these items states a different figure, follow that manufacturer's recommendation. . If more than one appliance is installed beneath a venting hood, and they have different minimum safety distances to the hood, adhere to the greater safety distance. 5 Appliance and cut-out dimensions KM 452 a Spring clips b There must be at least 3 3/16" (81mm) of usable depth on the right side of the cut out. ^ Seal the cut surfaces with a suitable sealant to avoid swelling caused by moisture. The materials used must be heat resistant. ^ Make the countertop cut-out following the dimensions given in the illustration. ^ Remember to maintain a minimum distance of 2" (50 mm) between the rear wall and a right or left hand side wall. See also "Important Safety Instructions". If, during installation, the seal around the frame does not sit flush with the countertop on the corners, the corner radius max. R4 (3/16") can be carefully filed down to fit. 6 Installation Installing the spring clips (75m m) 3 " Granite countertops b ^ Fix the supplied spring clips, a, at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 3. 5 x 25 mm screws supplied. For granite countertops, the spring clips, a, must be placed in position and secured with strong, double-sided adhesive tape. [. . . ] Only operate the cooktop once it has been installed into the countertop. Installer: Please leave these instructions with the consumer. ­ 120/240 V, 60 Hz, 50 A fuse rating or ­ 120/208 V, 60 Hz, 50 A fuse rating Black wire: connect to L1 (hot) Red wire: connect to L2 (hot) Green wire: connect to GND (ground) A dedicated line and junction box should be used to connect the cooktop to a 50 A circuit. [. . . ]