User manual MIELE KM5773

[. . . ] Operating and Installation Instructions Ceramic Cooktop with Induction KM 5773 To prevent accidents and appliance damage, read these instructions before installation or use. en - US M. -Nr. 06 766 180 Contents IMPORTANT SAFETY INSTRUCTIONS. 31 2 Contents Overheating protection . 50 3 IMPORTANT SAFETY INSTRUCTIONS READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE USING THE COOKTOP WARNING This appliance is intended for residential cooking only. [. . . ] The remaining time is displayed and can be changed at any time by pressing - or +. After the set time has elapsed the display shows 00 and an audible signal is heard. After a few seconds the tone will stop and the 00 will go out. ^ To end the signal select the m touch control. 26 Timer Automatic switch-off Use this function to turn a burner off automatically. The automatic switch-off can be used for several burners at the same time. ^ Turn the desired burner on and select a power level. ^ Select the m touch control until the indicator light for that burner flashes. If more than one burner is turned on, the indicator will light up clockwise from front left to front right with each touch of the m control. ^ Touch the - or + sensor until the desired time is displayed, e. g. Setting an additional burner If you would like to set another burner to switch-off automatically, repeat the above steps. If several different switch-off times are programmed, the shortest remaining time is shown in the display, and the indicator light for that burner will flash. The other indicator lights will show a steady light. If you would like to see the other remaining times: ^ Select the m touch control until the indicator light of the desired burner flashes. The set time counts down in minutes in the timer display. The remaining time is displayed and can be changed at any time by pressing - or +. 27 Timer Combi mode The timer and automatic switch-off functions can be used at the same time. If you are using the automatic switch-off function and would like to use the timer as well: ^ Touch the m sensor until the indicator light for the programmed burner(s) lights steadily and 00 appears in the display. If you are using the timer and would like to use the automatic switch-off function as well: ^ Touch the m sensor until the indicator for the desired burner flashes. After the last entry, the shortest remaining time will appear in the display. Toggle between functions Automatic switch-off function: Touch the m touch control until the indicator light for the desired burner flashes. Timer: Touch the m touch control until the indicator light for the desired burner is lit. Starting with the shortest remaining time which is shown in the display, all burners that are in use and the timer can be selected clockwise from left to right. Timer start value The timer is factory set so that the + and - touch controls start at 01 and 99 respectively. These settings can be adjusted so that they start with the most recently set (and completed) time (see "Programming - P14"). Example: You entered Program P14, Status S1, with the timer most recently set to 5 minutes. [. . . ] Any gap between the frame and the countertop will reduce as the cooktop is used. Installing the cooktop ^ Feed the cooktop connection cable down through the cut-out. ^ Place the cooktop centrally in the cut-out. When doing so make sure that the seal under the cooktop sits flush with the countertop on all sides. This is important to ensure an effective seal. [. . . ]